Electrolux 922718 설치 매뉴얼 - 페이지 12

{카테고리_이름} Electrolux 922718에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux 922718 32 페이지. Built-in hood for electric oven
Electrolux 922718에 대해서도 마찬가지입니다: 사용자 설명서 (24 페이지)

페이지 인쇄

D TRANSPORT, HANDLING AND STORAGE

D.1 Introduction

Transport (i.e. transfer of the machine from one place

to another) and handling (i.e. transfer inside

workplaces) must occur with the use of special and

adequate means.

CAUTION

• The machine must only be

transported, handled and stored

by specialised personnel, who

must have:

• specific technical training and

experience in the use of lifting

systems;

• knowledge of the safety

regulations and applicable laws in

the relevant sectors;

• knowledge of the general safety

rules;

• personal protective equipment

suitable for the type of operation

carried out;

• the ability to recognise and avoid

any possible hazard.

D.2 Handling

Arrange a suitable area with flat floor for machine

unloading and storage operations.

D.2.1 Procedures for handling operations

Before lifting:

• send all operators to a safe position and prevent

persons from entering the handling area;

• make sure the load is stable;

• make sure no material can fall during lifting.

Manoeuvre vertically in order to avoid impacts;

• handle the machine, keeping it at minimum height

from the ground.

For correct and safe lifting operations:

• use the type of equipment most suitable for

characteristics and capacity (e.g. electric pallet

truck or lift truck);

• cover sharp edges;

• check the forks and lifting procedures according to

the instructions given on the packaging.

D.2.2 Shifting

The operator must:

• have a general view of the path to be followed;

• stop the manoeuvre in case of hazardous

situations.

D.2.3 Placing the load

• Before placing the load, make sure the way is free

and that the floor is flat and can take the load.

• Remove the appliance from the wooden pallet,

move it to one side, then slide it onto the floor.

D.3 Unpacking

IMPORTANT

Immediately check for any

damage caused during

transport.

Inspect the packaging before

and after unloading.

1. Remove the packaging.

2. Keep all the documentation contained in the

packaging.

Note

• The forwarder is responsible for the goods during

transport and delivery.

• Make a complaint to the forwarder in case of

visible or hidden damage.

• Specify any damage or shortages on the dispatch

note.

• The driver must sign the dispatch note: the

forwarder can reject the claim if the dispatch note

is not signed (the forwarder can provide the

necessary form).

• For hidden damage or shortages becoming

apparent only after unpacking, ask the forwarder

for inspection of the goods within and not later

than 15 days after delivery.

D.4 Disposal of packaging materials

The packaging materials must be disposed of in

compliance with the current regulations in the country

where the appliance is used. All the packaging

materials are environmentally friendly. They can be

safely kept, recycled or burned in an appropriate

waste incineration plant. Recyclable plastic parts are

marked as follows:

Polyethylene

• Outer wrapping

• Instruction's bag

Polypropylene

• Straps

Polystyrene foam

• Corner protectors

The parts in wood and cardboard can be disposed of,

respecting the current regulations in the country

where the machine is used.