Andrew HELIAX HJ11-50 설치 지침 - 페이지 4

{카테고리_이름} Andrew HELIAX HJ11-50에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Andrew HELIAX HJ11-50 4 페이지. Coaxial cable

Drill through 4 insulator

guide holes with 3/16"

(4.7 mm) drill for gas-

pass operation

Notice

The installation, maintenance, or removal of antenna

systems requires qualified, experienced personnel.

Andrew installation instructions are written for such

personnel. Antenna systems should be inspected once

a year by qualified personnel to verify proper installa-

tion, maintenance, and condition of equipment.

Andrew disclaims any liability or responsibility for the

results of improper installation practices.

Andrew Corporation

10500 West 153rd Street

Orland Park, IL U.S.A. 60462

Place flare ring on insulator

and screw stud into stub so

that pin enters stub slot

Hold insulator and tighten

stud torqued to a range of

20-45 lb f -ft (27.1-61 N·m)

Telephone: 708/349-3300

FAX (U.S.A.): 1-800/349-5444

TELEX: 25-3897

Place 2 O-rings on helix ring and 1 O-ring on

insulator. Apply silicone grease to O-rings

and gasket and slide body into place.

Use 3 long screws, equally spaced, to pull

parts together. Add short screws then

replace long screws with short screws, and

tighten screws to 6-8 lb f -ft (8.1-10.8 N·m)

Want Andrew to attach connectors for you? Call us.

Skilled personnel at Andrew can attach connectors for

you, quickly and economically. Every factory-made

cable assembly is 100% tested before shipment and

has a 3-year warranty. For details about this service,

contact Andrew.

Customer Service, 24 hours: U.S.A. • Canada • Mexico: 1-800/255-1479

U.K.: 0800 250055 • Republic of Ireland: 1 800 535358

Other Europe: +44 592 782 612

Male

Female

Printed in U.S.A.9/95