Electrolux 922725 설치 매뉴얼 - 페이지 21

{카테고리_이름} Electrolux 922725에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux 922725 28 페이지. Built-in hood for electric and gas oven

페이지 인쇄

1. Installation and Assembly

3. Fix the hood and oven to the previously

assembled support (ref. F.3.1) using the

screws and toothed washers supplied, to

ensure mechanical fastening and the

equipotential

connection.

F.6 Air duct connection

The following items are arranged for the

connection of a 300x300 (118.11 x 118.11 inches)

duct:

922728

922732

922730

922729

922731

HOST11

HOSS11

HOSV11

HOST21

HOSS21

To install the ducts refer to the "Hood Installation

Diagram" (pages 2) and chapter E.2.1 (page15).

F.7 Water drain connection

The hood is supplied with a drain pipe DWO;

connect it to the main drainage system or to a

floor grate.

F.8 Electrical connection

IMPORTANT

The connection to the electrical

power supply must be in

compliance with the current

national and local regulations.

F.8.1 Power cable

Before connecting, make sure the voltage and

frequency match that given on the data plate.

• Connect the appliance to the power supply in a

permanent way with an H07 RN-F type cable

(NOT PROVIDED);

• Install the power cable in a metal or rigid

plastic pipe without any sharp parts;

• Install ahead of the appliance an omnipolar

switch of suitable capacity with contact gap of

at least 3 mm. Install the switch in the

building's electrical system, in the immediate

vicinity of the appliance;

• If required by local standards and regulations,

a RCBO circuit breaker with Idn 300mA class

A must be provided in the power supply circuit

by the installer;

• Appliance max. leakage current is 0.75 mA;