Electrolux 922731 설치 매뉴얼 - 페이지 10
{카테고리_이름} Electrolux 922731에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux 922731 28 페이지. Built-in hood for electric and gas oven
페이지 인쇄•
The connection point has an efficient earth contact and the mains voltage and frequency
match that given on the data plate. In case of doubts regarding the efficiency of the earth
wire, have the system checked by specialised personnel;
•
If the power cable is damaged, it must be replaced by Customer Care or in any case by
specialised personnel, in order to prevent any risk.
•
Check that a safety circuit breaker is installed between the power cable of the appliance
and the mains electric line. The max. contact gap and leakage current must comply with
the local safety regulations.
WARNING
The manufacturer declines any liability if the safety regulations are not
respected.
Positioning
A.6
•
Install the appliance, taking all the safety precautions required for this type of operation,
also respecting the relevant fire-prevention measures.
•
Handle the appliance with care in order to avoid damage or danger to people. Use a pallet
for handling and positioning.
•
The installation diagram gives the appliance overall dimensions and the position of
electrical connections and hood to oven cable. Check that they are available and ready for
making all the necessary connections.
•
NB: The room must have an adequate air inlets for the hood to be used at the same time
as appliances using gas or other fuels
•
The appliances are not suitable for recess-mounting. Leave a space of at least 50 mm
between the appliance and right side and rear walls and 500 mm from the left wall, or in
any case an adequate space to enable subsequent servicing or maintenance operations.
•
Suitably insulate surfaces that are at distances less than that indicated.
•
Ensure a distance of at least 100 mm between the appliance and any combustible walls.
Do not store or use flammable materials and liquids near the appliance.
•
Check and, if necessary, level the appliance after positioning. Incorrect levelling can cause
appliance malfunctioning.
Machine scrapping
A.7
•
Dismantling operations must be carried out by specialised personnel.
•
Work on the electrical equipment must only be carried out by specialised personnel, with
the power supply disconnected.
•
Make the appliance unusable by removing the power cable and any compartment closing
devices, to prevent the possibility of someone becoming trapped inside.
10