Electrolux DI 8821 운영 및 설치 매뉴얼 - 페이지 15

{카테고리_이름} Electrolux DI 8821에 대한 운영 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux DI 8821 20 페이지.

• Adjust extension of the hood support structure, as the final height of

the hood depends on this, and remember that with installation

completed the hood must be at least 50 cm above the hob top for

electric cookers and 65 cm for gas or mixed fuel cookers.

• Fix the two sections of the structure using 8 screws (2).

• Place the ceiling hole diagram directly above the hob top (3 - the

centre of the diagram must match the centre of the hob top and the

edges must be parallel to the sides of the hob top – the side of the

diagram with the wording FRONT corresponds to the control panel

side). Prepare the electrical connection.

• Drill as shown (6 holes for 6 wall plugs – 4 plugs for fixture), screw

the outer screws leaving a space of about 1 cm. between the screw

head and the ceiling (4).

• Fit an exhaust pipe inside the support (5) and connect it to the motor

compartment connection ring (exhaust pipe and fixing brackets are

not supplied).

• Hook the frame onto the 4 screws (6 - see also step 4).

CAUTION! The side of the support with connection box corresponds

to the side of the control panel with hood assembled.

• Tighten the 4 screws (7).

• Insert and tighten another 2 screws in the remaining free holes (8)

for secure fixing.

• Carry out the electrical connection (9) to the mains power supply,

only turn on the power supply upon completion of assembly.

• Hook the hood onto the support (10) , ensuring it fits properly – to

hook the hood onto the support partially tighten 4 screws (see also

step 12).

• Secure the hood to the support using 6 screws (11); this will also

help centre the two sections.

• Tighten the 4 screws securing the support to the hood (12).