Electrolux DI 8821 운영 및 설치 매뉴얼 - 페이지 8

{카테고리_이름} Electrolux DI 8821에 대한 운영 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux DI 8821 20 페이지.

Grease and charcoal filter maintenance

indicator

This hood is fitted with a device that indicates when it is necessary to

clean the grease filter or the charcoal filter (if the hood is used in the

recirculation version with a charcoal filter).

On delivery, the hood is not supplied with a charcoal filter, so the

saturation indicator will be disabled.

If the hood is to be used with a charcoal filter, the saturation

indicator light must be enabled as follows:

Press buttons 4 and 5 simultaneously and hold them for 3 seconds. At

first only the grease filter LED F will light up, but when the charcoal

filter LED C lights up the saturation indicator will be enabled.

To disable it: Press buttons 4 and 5 again simultaneously and hold

them for 3 seconds, until the charcoal filter LED C goes out.

Grease filter LED (F)

LED F will start to flash when it is time to clean the grease filter.

Cleaning will be necessary after 40 working hours. Always comply

with the maintenance instructions for the grease filter.

Charcoal filter LED (C)

The charcoal filter LED C will start to flash when the charcoal filter needs to

be replaced.

This operation is necessary after approximately 160 working hours.

Resetting the saturation indicator

After cleaning or replacing the filters, press button 1 for 3 seconds until

the grease filter LED F or the charcoal filter LED C stops flashing.