Basic setting
Pull-out system
Sabbath mode
1
Factory setting (may vary according to model)
15.2 Changing the basic settings
Requirement: The appliance is switched on.
Press
.
1.
Press "Basic settings".
2.
Press the required basic setting and use the control
3.
ring to change it.
The red bar next to the text field identifies the basic
setting that is currently selected. Its corresponding
value is shown in the display.
16 Cleaning and servicing
To keep your appliance working efficiently for a long
time, it is important to clean and maintain it carefully.
16.1 Cleaning products
In order to avoid damaging the various oven surfaces
on the appliance, do not use unsuitable cleaning
products.
WARNING ‒ Risk of electric shock!
An ingress of moisture can cause an electric shock.
Do not use steam- or high-pressure cleaners to
▶
clean the appliance.
Suitable cleaning agents
Only use cleaning agents that are suitable for the differ-
ent surfaces on your appliance.
Appliance front
Surface
Suitable cleaning agents Information
Stainless steel
¡ Hot soapy water
¡ Special stainless steel
Plastic or painted
¡ Hot soapy water
surfaces
E.g. control panel
Selection
Not retrofitted (if shelf sup-
ports and a single set of
pull-out rails are fitted)
Retrofitted (if two or three
sets of pull-out rails are fit-
ted)
Switched on
1
Switched off
cleaning products
suitable for hot sur-
faces
Use "Further settings" to scroll through the basic
4.
settings and, if required, use the control ring to
change any of these settings.
To save your changes, press
5.
1
to confirm.
Note: Your changes to the basic settings will be re-
tained even after a power failure.
Discarding changes to the basic settings
Press
▶
a All changes will be discarded and not saved.
15.3 Setting the time
Requirement: The appliance is switched on.
Press
1.
Press "Basic settings".
2.
3.
Press "Time".
Use the control ring to change the time.
4.
To save your changes, press
5.
to confirm.
ATTENTION!
Unsuitable cleaning products may damage the sur-
faces of the appliance.
Do not use harsh or abrasive cleaning products.
▶
Do not use cleaning products with a high alcohol
▶
content.
Do not use hard scouring pads or cleaning
▶
sponges.
Do not use any special cleaners for cleaning the ap-
▶
pliance while it is hot.
Using oven cleaner in a hot cooking compartment
damages the enamel.
Never use oven cleaner in the cooking compartment
▶
when it is still warm.
Remove all food remnants from the cooking com-
▶
partment and the appliance door before you next
heat up the appliance.
New sponge cloths contain residues from production.
Wash new sponge cloths thoroughly before use.
▶
Follow the instructions on cleaning the appliance.
→ "Cleaning the appliance", Page 21
To prevent corrosion, remove any limescale, grease, starch or albu-
min (e.g. egg white) stains on stainless steel fronts immediately.
Apply a thin layer of the stainless steel cleaning product with a soft
cloth.
Do not use glass cleaner or a glass scraper.
To avoid permanent stains, remove any descaling agent that gets
onto the surface immediately.
Cleaning and servicing en
and use "Do not save" to confirm.
.
and use "Save"
and use "Save"
19
페이지 인쇄