Bosch 8 Series 사용 설명서 - 페이지 27

{카테고리_이름} Bosch 8 Series에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch 8 Series 48 페이지. Combi steam oven
Bosch 8 Series에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (21 페이지), 조립 지침 (4 페이지), 설치 및 사용 설명서 지침 (16 페이지), 빠른 참조 매뉴얼 (2 페이지), 사용자 설명서 및 설치 지침 (44 페이지), 시작하기 (7 페이지), 사용 설명서 (32 페이지), 사용자 설명서 및 설치 지침 (32 페이지), 사용 설명서 (12 페이지), 사용자 설명서 및 설치 지침 (24 페이지), 사용자 설명서 (28 페이지), 사용자 설명서 및 설치 지침 (28 페이지), 설치 및 사용 설명서 지침 (20 페이지), 사용자 설명서 및 설치 지침 (44 페이지), 사용 설명서 (12 페이지), 사용자 설명서 및 설치 지침 (40 페이지), 사용자 설명서 및 설치 지침 (32 페이지), 사용 정보 (20 페이지)

Bosch 8 Series 사용 설명서

AquaSensor *

* depending on the features of your
A q u a S e n s o r
dishwasher
The Aqua sensor is an optical
measuring device (light barrier) which
measures the turbidity of the rinsing
water.
The AquaSensor is used according
to the programme. If the AquaSensor is
active, "clean" rinsing water can be
transferred to the next rinse bath and
water consumption can be reduced by
3–6 litres. If the turbidity is greater,
the water is drained and is replaced
with fresh water. In the automatic
programmes the temperature
and running time can also be adjusted
to the degree of soiling.

Zeolith drying

:
Warning
Z e o l i t h d r y i n g
Risk of burns from touching the blow
opening 1R!
Never touch the blow opening. The blow
opening becomes hot and, furthermore,
any damage will result in a chargeable
callout by customer service.
Caution!
Please ensure that the intake opening
1J is not obstructed and do not place
any temperature-sensitive utensils in the
lower basket at the rear right side above
the blow opening 1R.
The appliance features a Zeolith
container. Zeolith is a mineral which can
store moisture and heat energy
and release them again.
¼
Operating the appliance en
During the washing step this heat
energy is used to dry the mineral
and heat up the rinsing water.
During the drying phase moisture from
the rinsing compartment is stored in
the mineral and heat energy
is released. This released heat energy is
blown into the rinsing compartment with
dry air. This accelerates and improves
drying.
These processes therefore save a great
deal of energy.

Time display

The running time is determined during
the programme by the water
temperature, the number of utensils as
well as the degree of soiling and may
vary (depending on the selected
programme). You can change the time
display in time or hours/minutes so that
the remaining running time of the rinsing
progamme appears in the display
window "Ready at" (for example 15:20
hours) or "Ready in" (for example 3:25).
27