Atlantic ECOBLOX-74243 제품 설명서 - 페이지 3

{카테고리_이름} Atlantic ECOBLOX-74243에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Atlantic ECOBLOX-74243 17 페이지.

5. Install the top large panel by inserting the slide lock tabs of all four small panels into the

receiving channels and slide until the panel is snug.

6. Flip the Eco-Blox on its side and push down where the large and small panels meet until

all edges are aligned.

7. To complete the assembly, rotate the Eco-Blox so that the bottom panel is flat on the

ground and the top panel is facing up. In this position, the top panel is supported by the

sides as well as the center support panels. EcoBlox must always be installed in this

position. Improper installation will reduce the structural integrity of the unit and may

cause the Eco-Blox to fail.

Building Multiple Eco-Blox Modules

Start with an assembled Eco-Blox. The top panel

replaces the bottom panel from Step 1.

Begin by installing the 4 small panels from Step 2

onto the finished Eco-Blox and continue through

Step 7. Repeat for taller Eco-Blox modules.

Installation

Eco-Blox water matrix reservoirs are a strong,

versatile way to store water underground,

but a few guidelines must be followed for

proper performance and longevity.

EcoBlox must be oriented with the top panel

covering the edges of all vertical panels. Setting

the Eco-Blox on its end or side, with exposed edges on top, will allow the panels to

decouple under load and potentially, collapse.

CORRECT

ORIENTATION

INCORRECT

ORIENTATION