Bosch B24CB80ESB 사용 및 관리 매뉴얼 - 페이지 19
{카테고리_이름} Bosch B24CB80ESB에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch B24CB80ESB 21 페이지.
Bosch B24CB80ESB에 대해서도 마찬가지입니다: 사용 및 관리 매뉴얼 (44 페이지)
페이지 인쇄
Issue
Condensation accumulates on the
surface of the appliance and on
the shelves inside.
A large volume of condensation
collects regularly in the fruit and
vegetable container.
Water output is reduced.
Water is dripping from the water
dispenser.
The water dispenser is not func-
tioning.
Ice cube production is low.
The ice maker is not functioning.
Cause and troubleshooting
The water contained in warm and humid air condenses on the colder surfaces of the
appliance.
Wipe away the water with a soft, dry cloth.
1.
Open the appliance as briefly as possible.
2.
Ensure that the appliance is always closed properly.
3.
Depending on the food and quantity stored, condensation may form in the fruit and
vegetable container.
Remove the fruit and vegetable container. → Page 16
1.
Remove the ventilation clips
2.
Low water pressure.
Check the pressure of the water supply system or the external water filter sys-
▶
tem, e.g. reverse osmosis system.
Connect the appliance only to a water connection with sufficient water pressure.
The water filter is blocked.
Change the water filter.
▶
Air is in the water system.
Keep dispensing water until it contains no more air.
▶
There is no water being supplied to the appliance.
Ensure that there is a water supply and that the shut-off valve on the water con-
▶
nection is open.
Contact an installer if necessary.
Kink in the water hose.
Turn off the water supply and straighten the kink in water hose.
▶
If necessary, replace the water hose.
The appliance has only recently been connected.
Wait approximately 4 hours until the first batch of ice cubes is ready.
▶
The freezer compartment has been opened frequently or for an extended period of
time.
Check ice cube production after a few hours.
▶
Low water pressure.
Check the pressure of the water supply system or the external water filter sys-
▶
tem, e.g. reverse osmosis system.
Connect the appliance only to a water connection with sufficient water pressure.
The water filter is blocked.
Change the water filter.
▶
Food or objects are blocking the fill level sensor for the ice maker.
Remove all food and objects from the ice storage container.
▶
Fault in the ice maker.
Switch off the appliance. → Page 10
1.
Disconnect the appliance from the power supply.
2.
Unplug the power plug or switch off the circuit breaker in the fuse box.
Reconnect the appliance after 5 minutes.
3.
If the fault persists, call customer service. → Page 21
4.
Ice cube production is switched off.
Switch on ice cube production.
▶
There is no water being supplied to the appliance.
and rotate them before inserting again
Troubleshooting en-us
.
19