Atlantic PV1700 사용 설명서 - 페이지 6
{카테고리_이름} Atlantic PV1700에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Atlantic PV1700 16 페이지. Oasis series skimmer, filterfalls, pump vault, fastfalls
Atlantic PV1700에 대해서도 마찬가지입니다: 제품 설명서 (12 페이지)
Oasis Skimmer Installation
EXCAVATING AND SETTING THE PS3900
Prior to setting the skimmer you must first determine the surface level of the water in
the pond. Once you have this number you can excavate for the Skimmer. The excavation
should be a few inches wider and longer than the Skimmer body. The depth of excavation
for the PS3900 should be 15" below water level. Do not dig too deep. The skimmer
should be set on stable, compacted soil. In the case that you over-dig, be sure to compact
the soil thoroughly to prevent settling. The bottom of the hole should be level side-to-
side and front-to-back (Figure 5).
Figure 5.
15"
Place the skimmer enclosure into the excavated hole. Check the top of the enclosure to
make sure that it is level front-to-back and side-to-side. Check where your pre-determined
water level falls on the face of the skimmer enclosure. Water level should be 11/4" below
the top of the weir door opening.
Make sure that any unexcavated soil that is left in front of the Skimmer is at least 10"
below water level. This will ensure that there is enough room for the weir door to be
installed and function properly.
Before you go any further into the Skimmer installation, it is a good idea to place a few
stones inside the Skimmer enclosure to weigh it down and keep it from moving.
Prior to backfilling the enclosure, make sure the support bar is installed inside the
skimmer. The support bar must be in place for the enclosure to retain its shape during the
backfilling process. Loosely backfill the enclosure on all sides, lightly compacting as you
go. Do not over-compact the soil! Aggressive compaction may deform the enclosure and
cause components to fit improperly.
ATTACHING THE LINER
Hold the liner up against the face of the Skimmer, allowing a minimum of 2" to extend
above the top of the enclosure. Leave some excess slack in the liner below the weir
opening. This will help alleviate any future strain on the liner connection.
Make sure that the front surface of the Skimmer, and the back side of the liner, are clean
and free of debris. When you are satisfied with the position of the liner, clip it in place with
the provided spring clips. With a sharp razor knife, cut a hole in the liner for the weir door
using the hole in the face of the skimmer as a guide (Figure 6).
6
1
1
/
"
4
WATER LEVEL
10" MIN