Atlantic 73898 제품 설명서 - 페이지 3

{카테고리_이름} Atlantic 73898에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Atlantic 73898 17 페이지.

Before You Start

• Check the model name plate to make sure once again that the product is of the correct

voltage and frequency rating.

• The setting on the circuit breaker or other overload protector should be made in

accordance with the rated currency of the pump.

• Turn off the power supply or circuit breaker before inserting the power supply plug to

avoid electrical shock, shorting, or unexpected starting of the pump, which could lead

to injury.

• Never operate the pump while it is suspended in air. The recoil may result in injury or

other major accident.

Electrical Safety

• Electrical wiring should be installed by a qualified electrician in accordance with all

applicable safety regulations. Incorrect wiring can lead to a pump malfunction, electrical

shock or fire.

• Pumps should operate on a designated, circuit rated at 15 Amps (minimum).

• Pump must be protected by a ground fault circuit interrupter (GFCI).

• Pump must be plugged into a standard, properly grounded, three pronged outlet.

• Do not cut the electrical cable. If a cable with cut insulation or other damage is submerged

in water, there is danger of water seeping into the pump motor and causing a short. This

may result in damage to the pump, electrical shock or fire. Altering the electrical cable in

any way will void the warranty.

• Never move or handle the pump by pulling on the electrical cable. Make sure the electrical

cable does not become excessively bent or twisted, does not rub against a structure in a

way that might damage it, and does not come in contact with heated surfaces.

• In case of a power outage, turn off the power to the pump to avoid having it start

unexpectedly when the power is restored.

• L-Series pumps are cooled internally as the water flows around the motor. Entire pump

including intake screen must be completely submersed during operation.

• In case of very excessive vibration, unusual noise or odor, turn off the power immediately and

consult with your nearest dealer. Continuing to operate the pump under abnormal

conditions may result in electrical leakage, electrical shock or fire.

• The pump has a built-in motor protection system. The following reasons may cause the

pump to stop automatically regardless of water level.

• Motor overheating

• Excessive current

• Change in voltage polarity

• Open-phase operation or operation under constraint

• Repeating cycles of stopping and restarting will damage the water pump. Do not

continue operation at low lift, low water level, or while the inlet is clogged with debris.

Not only will performance suffer, but also such conditions may cause noise, heavy

vibration, and pump failure.