Atlantic Technology 3.1 HSB 사용 설명서 - 페이지 6

{카테고리_이름} Atlantic Technology 3.1 HSB에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Atlantic Technology 3.1 HSB 12 페이지. High performance front channel speaker base with powered h-pas subwoofer

페이지 인쇄

6 Connecting Your System

Rear View

1. Standby/Status: Controls and indicates the

power and auto sensing circuit

2. DC IN: Input connector for power supply

3. Lowpass Control: Controls the internal low pass

ﬁ lter

Connecting Your System

Follow the SYSTEM WIRING DIAGRAM to connect the 3.1HSB to your system.

SUBWOOFER: Use a quality RCA cable to connect from the SUB output on your A/V

receiver to the subwoofer INPUT (7) on the back of the 3.1 HSB.

FRONT CHANNEL SPEAKERS: Using high quality dual conductor stranded wire of

16 gauge or heavier, connect the speaker wires from the output terminals on the A/V

Receiver to the appropriate speaker input terminals on the back of the 3.1 HSB. The

lower the gauge number, the heavier the wire. Use heavier gauge wire for runs over 25'

(7.62m).

Remove ½ inch (6mm) of insulation from the end of each wire. Push down on the ter-

minal connector and an opening will appear in the connector that is capable of hold-

ing heavy gauge wire. Insert the bare wire into the opening and release the terminal. Be

sure to observe correct polarity, connecting the positive (+) leads to the red terminals and

Tested to Comply with FCC Standards for Home or Office Use.

U.S. Patent 8,094,855 B2. H-PAS is a trademark of AT Int'l Corp,

4. Bypass switch: Activates the Lowpass control

5. Phase switch: Controls the phase of the subwoofer

6. Level control: Controls the subwoofer output level.

(volume control)

7. Input: Subwoofer input (RCA connector)

8. Front Left, Center, Right Speaker Inputs

3.1 HSB Speaker Base System with H-PAS