Electrolux ERHC938S 설치 및 사용 설명서 - 페이지 10
{카테고리_이름} Electrolux ERHC938S에 대한 설치 및 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux ERHC938S 16 페이지. Canopy cooker hood
Electrolux ERHC938S에 대해서도 마찬가지입니다: 설치 및 사용 설명서 (14 페이지)
페이지 인쇄
10
CHANGING THE HALOGEN LAmPS
WarnIng!
Ensure lamp is cool before removing.
Using a small flat blade screw driver remove the inner
stainless steel ring to obtain access to the halogen globe.
When removing the inner ring, do so carefully, as the glass
lense could easily fall out of the inner ring. Remove the
halogen globe, whilst cool, and replace carefully with a
new globe.
TROUBLE SHOOTING
problem
The cooker hood will not start
The cooker hood is not working
The cooker hood has switched off during
operation
If you have completed all of the above checks and are still experiencing difficulty, please contact your local
Electrolux Service Centre.
ErHC1238S cooker hood has 4 x 20W, 12 volt
halogen globes
ErHC938S cooker hood has 3 x 20W, 12 volt
halogen globes
Important!
When handling globes hold with a cloth or gloves to
ensure perspiration does not come into contact with
a globe as this can reduce the life of the globe.
troubleshooting guide
remedy
• C heck that cooker hood is connected to an electrical supply.
• C heck that a fan speed has been selected.
• C heck that fan speed is high enough for the task.
• T he grease filters are clean.
• T he kitchen is adequately vented to allow entry of fresh air.
• C heck ducting and outlets are not blocked.
• T he safety device may have tripped – turn off the cooking
appliance and wait for the device to reset. If the hood is
installed below the heights indicated in the installation
instructions the motor will cut out frequently which will damage
the cooker hood.