Electrolux ERHC938S 설치 및 사용 설명서 - 페이지 7

{카테고리_이름} Electrolux ERHC938S에 대한 설치 및 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux ERHC938S 16 페이지. Canopy cooker hood
Electrolux ERHC938S에 대해서도 마찬가지입니다: 설치 및 사용 설명서 (14 페이지)

페이지 인쇄

COOKER HOOd INSTALLATION (CONT)

If additional or alternative mounting points are required

there are 4 x m10 threaded mounting points on the top of

the cooker hood as highlighted in the image below.

m10

4. Prior to installing the cooker hood into position,

fix exhaust transition duct using screws supplied,

ensuring the seal is between the cooker hood top

panel and the base of the exhaust transition (Fig. d).

4a. I f required, fit the dampers and secure with clamps,

duct tape or cable ties.

Transition pieces

ERHC1238S - 1200mm model

Transition piece

screw holes (4 places)

Fig. C

Fig. D

5. mounting and securing the transition pieces is shown

in Fig. d.

WarnIng!

Use screws provided to secure transition piece at

preformed holes. Using alternate screws and hole

locations may cause an electricl safety risk.

6. Hang hood on the mounting screws, tighten mounting

screws then secure at the anti-tilt locations as

indicated in Fig. B.

WarnIng!

Due to product weight, take appropriate measures to

lift and position the product to avoid injury.

7. The canopy cooker hood has been supplied with duct

transition piece/s, 200mm diameter non-combustible

flue pipe must be used with the transition piece/s.

Continue the centre line to the ceiling. Fit preferred flue

pipe to the fan transition duct (Fig. d1 & d2,

see page 11).

Use worm drive clamps, cable ties or suitable duct tape to

secure flexible pipe to the transition duct.

NOTE: We recommend extending flue pipe through the

roof to external roof cowl to vent exhaust externally.

We do not recommend venting into ceiling cavity.

NOTE: To ensure optimum performance of the cooker

hood, the use of 200 mm diameter rigid ducting is

recommended. The use of bends should be avoided.

Rigid flexible ducting is suitable, although loose flexible

ducting is unacceptable. All ducting must be fire retardant.

electrical connection

Check that the installation complies with the standards

of local building, gas and electrical authorities. Before

connecting to the mains supply ensure that the mains

voltage corresponds to the voltage on the rating plate

inside the cooker hood.