Electrolux ERI935DSE 매뉴얼 - 페이지 8

{카테고리_이름} Electrolux ERI935DSE에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux ERI935DSE 12 페이지.

www.electrolux.com

4. CONTROLS

Button Function

• Lamps in risk group 1 under

IEC/EN62471 at a distance

of 20cm and is exempt

from risk group under IEC/

EN62471 at a distance of

30cm.

• For replacement contact techni-

cal support ("To purchase contact

technical support").

Turns the lights on/off at maximum strength.

Turns the motor on/off at speed one.

Turns the Motor on at speed two.

Press and hold the button for approximately 3 seconds,

with all the loads turned off (Motor and Lights), to turn the

Activated Charcoal Filter alarm on. The relevant LED flashes

twice to confirm.

To turn the alarm off, press the button again and hold for at

least 3 seconds. The relevant LED flashes once.

Turns the Motor on at speed three.

Press and hold the button for approximately 3 seconds, with

all the loads turned off (Motor and Lights), to perform a reset.

The LED S1 flashes three times.

Turns the Motor on at INTENSIVE Speed.

This speed is timed to run for 6 minutes. At the end of this

time, the system returns automatically to the speed that was

set before. If it is activated with the motor turned off, the hood

will switch to OFF at the end of the time.

Signals the Metal Grease Filter saturation alarm, indicating that

it is necessary to wash the filters. The alarm is triggered after

the Hood has been in operation for 100 working hours.

When this is activated, it signals the Activated Charcoal Filter

saturation alarm, indicating that the filter must be changed;

the Metal Grease Filters must also be washed. The Activated

Charcoal Filter saturation alarm comes into operation after the

Hood has been working for 200 hours.

Led

Fixed.

Flashing.