Atlantic Technology ICTS-6.1-IP 설치 지침 - 페이지 2

{카테고리_이름} Atlantic Technology ICTS-6.1-IP에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Atlantic Technology ICTS-6.1-IP 2 페이지. Ceiling speakers

페이지 인쇄

New Construction and Retrofit Installations

Note: A new construction rough-in kit and back box kit are optionally

available from Atlantic Technology. Please refer to the instructions included

in those kits for their use. If the rough in kit has been used please go directly

to Step 2 below.

Mounting Hole Specifications:

ICTS-6.1: Diameter = 7

⁄

in., 188mm; Depth = 4

Cut an appropriately sized opening in the ceiling material. Be sure that the

ceiling material can support the weight of the speaker. Also be sure that

the sides of the opening are at least 1 ½ inches away from any beams or

studs within the cavity. If it is not, the rotating clamps will be restricted

in their movement and may not clamp properly.

Figure 1

No less than 1 ½"

Joist

or Stud

Be sure that all foreign material in the ceiling is kept out of the speaker

assembly, particularly the back of the woofer cone. There is a cloth shield

on the rear of the woofer, but please use care anyway.

For conventional Connection to an audio amplifier/receiver:

Attach the speaker wires that have been already run through the ceiling

to the speaker terminals. Simply remove ½ inch of insulation from the

end of each input wire. Push down on the terminal connector and an

opening will appear in the connector that is capable of holding up to 14

gauge wire. Insert the bare wire into the opening and release the terminal.

Be sure to observe correct polarity, connecting the positive (+) leads to

the red terminals and the negative (-) leads to the black terminals. Also

be sure that no stray strands of wire touch across any terminals. See

Figure 2.

Figure 2

⁄

in., 118mm

Joist

or Stud

For Connection to an IP-type system, like NetStreams®:

Unscrew the 4 setscrews

on top of the built-in

Phoenix connector and

pull the wires away from

the connector. See Figure

3 (You may tie or clip the

wires that used to connect

here.)

Connect the wires from

the NetStreams amplifier

to the ICTS-6.1's Phoe-

nix connector and screw

down tightly. Consult your

NetStreams manual for

wiring details.

Mount the speaker in the ceiling.

Tighten the mounting screws one at a time. As you tighten the screws,

the clamps on the back of the assembly will turn and lower, grabbing

the back of the ceiling and sandwiching the ceiling between themselves

and the frame's circular trim ring.

Snug all four mounting screws in this manner. Be careful not to over-

tighten them.

IMPORTANT: If you are using an electric screwdriver, make sure it is

set to the "low torque" position.

You may now install the grille into the frame by gently pushing it into

the recess.

Figure 4

Ceiling

Atlantic Technology

343 Vanderbilt Avenue Norwood, MA 02062

(781) 762-6300 www.atlantictechnology.com

Grille

Figure 3

015-1061