Electrolux FHWC3055LSA 사용 및 관리 매뉴얼 - 페이지 7

{카테고리_이름} Electrolux FHWC3055LSA에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux FHWC3055LSA 13 페이지. 30 and 36 free-standing range hood
Electrolux FHWC3055LSA에 대해서도 마찬가지입니다: 사용 및 관리 매뉴얼 (13 페이지), 사용 및 관리 매뉴얼 (13 페이지)

페이지 인쇄

Examples of possible ducting or air

recirculation

fig.

Roof pitch with

Sidewall cap

flashing and cap

Pipe

Collar

Installing range hood to the wall

(Exhaust operation)

IMPORTANT

This range hood is very heavy. Adequate structure

and support must be provided in all types of

installations.

Install framing for hood support

• If drywall is present, mark the screw hole

locations.

• Cut away enough drywall to expose 2 vertical

studs at the holes location indicated by the

template. Install two horizontal supports at least

1" x 6" between two wall studs at the bottom and

top mounting holes installation location (fig. ).

• The horizontal support must be flush with the

room side of the studs. Use cleats behind both

sides of the support to secure to wall studs.

• Reinstall drywall and refinish.

Recirculator

Pipe

Collar

Framing must be capable of supporting 100 lbs.

Step 1:

• Make sure that no cables or pipes will become

damaged (e.g. electric, gas, water; test the areas

in question with a cable detector).

• Using supplied template (15), mark and drill 8

holes in the wall. Drill the holes according to the

measured distances from the diagram (fig.

• Upper/Lower bracket (3, 4): Insert 4 wall plugs (9)

into the 4 drilled holes.

• Range hood (1): Installation is depending on wall

type:

Wall type

Wood

Brick/Concrete

Installing the hood

fig.

IMPORTANT

Required fasteners

No wall plugs (9)

required

4 wall plugs (9)