Atlantic Technology 212 SB 사용 설명서 - 페이지 6

{카테고리_이름} Atlantic Technology 212 SB에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Atlantic Technology 212 SB 12 페이지. Sb-series box subwoofers
Atlantic Technology 212 SB에 대해서도 마찬가지입니다: 제품 정보 시트 (2 페이지)

페이지 인쇄

Connecting Your Subwoofer

L/MONO

Connecting Your Subwoofer

Use the low-level (RCA jack) subwoofer line out of your surround sound

receiver/processor. Simply connect your subwoofer with a high quality

shielded cable as shown in the diagram on page 7. Please consult your

processor/receiver manual for further information.

WARNING: To prevent risk of electrical shock or damage to your

equipment, always unplug all component AC cords before pro-

ceeding with speaker and component connections! The last step in

wiring your system should be plugging in the AC cords!

Subwoofer Line Out to Low Level In

Run an RCA cable from your receiver's Sub Out jack to the L/Mono input

jack on the back of the subwoofer (Figure 3). If your receiver/processor

has stereo subwoofer outputs, connect these to both the L/Mono and R

AC INPUT

jacks on the back of the subwoofer (Figure 4).

50-60Hz 300W MAX

Using the Low Level Output

110-120V

220-240V

If desired,you can run a low level signal through the subwoofer and out

to another unit.This way you can add an additional subwoofer with mini-

mal additional wiring. The signal that comes out of the output jacks is

identical to the input signal.

OFF

Power Connection

FOR 110-120VAC, USE 3A L 250V FUSE

FOR 220-240VAC, USE 2A T 250V FUSE

into the switched outlet of an ampliﬁer, preampliﬁer, or receiver. The

power demands of the subwoofer ampliﬁer may exceed the power rating

of the switched outlet and may damage the equipment.

Connect the power cord to an AC

outlet only after making all other

connections to the subwoofer. This

will avoid any chance of accidentally

activating the subwoofer while wir-

ing. Atlantic Technology does not

recommend plugging the subwoofer

Model 102, 212 and 422 SB Powered Subwoofer

Figure 2

AC Connection

Your subwoofer is totally automatic in its operation. The automatic on/

off circuitry will only activate the subwoofer in the presence of an audio

signal from your system.After 7-10 minutes with no signal detected from

the rest of the system, the ampliﬁer will shut itself off and go back into

standby mode.When the sub is in operating mode, the status LED will

glow green. The LED will glow amber in the Standby mode and power

consumption in this mode is negligible.Standby operation can be com-

pletely bypassed by placing the standby switch on the rear panel to the

ON position.