Electrolux Icon E36WC45FSS 사용 및 관리 매뉴얼 설치 지침 - 페이지 10
{카테고리_이름} Electrolux Icon E36WC45FSS에 대한 사용 및 관리 매뉴얼 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux Icon E36WC45FSS 24 페이지. Electrolux e36wc45fss range hood: supplementary guide
Electrolux Icon E36WC45FSS에 대해서도 마찬가지입니다: 사양 시트 (2 페이지), 공장 부품 카탈로그 (4 페이지), 사용 및 관리 매뉴얼 (24 페이지)
페이지 인쇄
10
Operation
Halogen Bulbs
This range hood requires two halogen bulbs (Type JC, 12Volt, 20Watt Max, G-4 Base).
Always switch off the electrical supply before carrying out any operation on the appliance.
Figure 2
FUSE
ELECTRICAL
Figure 3
BOX
WARNING
To change bulbs:
1 Open the cover by prying from the proper slots.
2 Remove the bulb by pulling sideways. (DO NOT ROTATE).
3 Replace with Type JC, 12Volt, 20 Watt Max, G-4 Base halogen bulb. Do not
touch replacement bulb with bare hands!
CAUTION
Bulb may be hot.
Fuse Placement
CAUTION
Use of bulbs greater than 20 watts will cause the fuse to open.
IF LIGHTS FAIL TO OPERATE, DISCONNECT POWER AT THE SERVICE
ENTRANCE. CHECK THE FUSE AND REPLACE IF NECESSARY.
1 Raise or remove the lower decorative flue. See Figure 3.
2 Remove the cover from the electrical box.
3 Unscrew the cap from the fuse holder and remove the fuse.
4 Replace the fuse with the same size and amperage (5 x 20mm, 4 amp,
125 volt).
CAUTION
Use of a fuse greater than 4 amps may damage the transformer.
5 Reinstall the fuse holder cap, electrical box cover and flue.
6 Reconnect power at the service entrance.