Atlantic Technology SB-900 사용 설명서 - 페이지 3
{카테고리_이름} Atlantic Technology SB-900에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Atlantic Technology SB-900 4 페이지. High performance powered subwoofer
페이지 인쇄Instruction Manual
SB-900 Subwoofer Rear Panel
Figure 1
12
Status LED
1
This will be green for "on" condition, red for "standby"
Standby Switch
2
When in ON position, the amplifier will always be on. When in the
AUTO position, the amplifier will be in Automatic Standby Mode.
Phase Switch
3
This switch allows precise acoustic matching with satellite speaker
systems whose output may be phase reversed. Try in both the
highest and lowest positions — use the position that results in the
strongest bass output.
Bass Level Control
4
Use this control to set the level of bass desired
Low-Pass Control
5
An adjustable (55Hz to 200Hz) @ 18dB per octave low-pass
crossover.
Low-Pass Switch
6
When in the LOW-PASS position, adjustment of the crossover can
be made by the Crossover Control. If being fed a pre-filtered or THX
signal, place the switch at the BYPASS position.
SB-900 Manual.indd 3
1
2
3
4
PHASE
INVERT
NORMAL
LEVEL
LOWPASS
AUTO
OFF
ON
STATUS
MIN
MAX
40
OUTPUT
RIGHT
L / MONO
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK.
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
AVIS: RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR
FOR CONTINUED PROTECTION AGAINST RISK OF FIRE,
REPLACE ONLY WITH SAME TYPE AND RATING OF FUSE
DOUBLE INSULATION - WHEN SERVICING,
USE ONLY IDENTICAL REPLACEMENT PARTS
SERIAL
SB900BJRWWY80100
MODEL
SB-900-BLK Powered Subwoofer
5
6
7
80
RIGHT
LOW LEVEL
L / MONO
BYPASS
220
INPUT
HIGH LEVEL
RIGHT
L / MONO
AC INPUT
50-60 HZ 180W MAX
110-120V
220-240V
FOR 110-120V, USE T2AL 250V FUSE
FOR 220-240V, USE T1AL 250V FUSE
ENGINEERED IN THE USA,
MANUFACTURED IN CHINA
Low Level Input
7
Use the input to connect to the subwoofer or LFE line out from
your processor/receiver.
High Level Output
8
Connect main Left/Right speakers here when using the High
Level Input.
High Level Input
9
If your electronics do not have a line-level sub out, connect the Left-
Right speaker terminals of your electronics to these connections.
Set the SB-900's crossover to "Lowpass, " and adjust accordingly.
AC Input
10
Use the included power cord to connect your amplifier to a wall
outlet.
11
Voltage Select Switch
Voltage switch for use in different countries. This switch will be set
when you receive the unit. Change this setting only when you are
sure your application requires it. For US, the switch should be set
to the 115V position.
12
Product Serial Number
Write this number in the space provided on page 2 for future
reference.
8
9
10
11
10/18/10 3:19:35 PM
3