Making the electrical connections
Electrical Shock Hazard
wiring this unit.
ê2û V AC, ê5 or 2û Amp cir
ê2û V
ê2û V
ê2û V
ê2û V
AC, ê5 or 2û Amp cir
AC, ê5 or 2û Amp cir
AC, ê5 or 2û Amp cir cuit r
AC, ê5 or 2û Amp cir
ELECTRICAL GROUNDING INSTRUCTIONS
ELECTRICAL GROUNDING INSTRUCTIONS
ELECTRICAL GROUNDING INSTRUCTIONS
ELECTRICAL GROUNDING INSTRUCTIONS
ELECTRICAL GROUNDING INSTRUCTIONS
THIS APPLIANCE IS FITTED WITH AN ELECTRICAL
JUNCTION BOX WITH À WIRES, ONE OF WHICH
ô GREEN/YELLOWÈ SERVES TO GROUND THE
APPLIANCE. TO PROTECT YOU AGAINST
ELECTRIC SHOCK, THE GREEN AND YELLOW
WIRE MUST BE CONNECTED TO THE
GROUNDING WIRE IN YOUR
HOME ELECTRICAL SYSTEM, AND IT MUST
UNDER NO CIRCUMSTANCES BE CUT OR REMO-
VED.
Failure to do so can r
Failur
Failur
Failur
Failur
e to do so can r
e to do so can r
e to do so can r
e to do so can result in death or electrical
esult in death or electrical
esult in death or electrical
esult in death or electrical
esult in death or electrical
shock.
shock.
shock.
shock.
shock.
Remove junction box cover and knockout on the
top left side.
If not already done, install ê/2" conduit connector
in junction box.
cuit requir
cuit r
cuit r
cuit r
equir
equir
equired.
equir
ed.
ed.
ed.
ed.
Installing the hood
Run black ô liveÈ , white ô neutralÈ , and green ô earthÈ
wires ô í êù AWGÈ according to the National
Electrical Code or CSA Standards and local
codes and ordinances in ê/2" conduit from power
supply to junction box.
Connect black, white, and green wires from
power supply to black, white, and green/yellow
wires in junction box respectively.
These connections should be done always
making reference to the electrical diagram found
inside the hood.
Close junction box cover and reapply screws.
13
페이지 인쇄