Electrolux ICON RH42PC60GS 설치, 사용 및 관리 매뉴얼 - 페이지 11
{카테고리_이름} Electrolux ICON RH42PC60GS에 대한 설치, 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux ICON RH42PC60GS 19 페이지. 42" glass canopy island hood
Electrolux ICON RH42PC60GS에 대해서도 마찬가지입니다: 브로셔 및 사양 (2 페이지), 설치, 사용 및 관리 매뉴얼 (21 페이지), 브로셔 및 사양 (2 페이지)
Ceiling ducting
Ceiling ducting
Ceiling ducting
Ceiling ducting
Ceiling ducting
• Use the template previously installed to prepare a
8-½" hole in the ceiling for ductwork.
8 1/2"
8.43" - 10"
minimum ceiling
7.93" - 10"
minimum ceiling
Making the electrical connections
Electrical Shock Hazard
Warning: Turn off power at the service panel before
wiring this unit.
120 VAC, 15 or 20 Amp cir
120 V
120 V
120 V
120 V
AC, 15 or 20 Amp cir
AC, 15 or 20 Amp cir
AC, 15 or 20 Amp cir
AC, 15 or 20 Amp circuit r
ELECTRICAL GROUNDING INSTRUCTIONS
ELECTRICAL GROUNDING INSTRUCTIONS
ELECTRICAL GROUNDING INSTRUCTIONS
ELECTRICAL GROUNDING INSTRUCTIONS
ELECTRICAL GROUNDING INSTRUCTIONS
THIS APPLIANCE IS FITTED WITH AN ELECTRICAL
JUNCTION BOX WITH 3 WIRES, ONE OF WHICH
(GREEN/YELLOW) SERVES TO GROUND THE
APPLIANCE. TO PROTECT YOU AGAINST
ELECTRIC SHOCK, THE GREEN AND YELLOW
WIRE MUST BE CONNECTED TO THE
GROUNDING WIRE IN YOUR
HOME ELECTRICAL SYSTEM, AND IT MUST
UNDER NO CIRCUMSTANCES BE CUT OR REMO-
VED.
4 12/16" (At least)
23 12/16"
30" Gas Cooktop (min)
24" - 30" Electric Cooktop (min)
cuit requir
cuit r
cuit r
cuit r
equired.
equir
equir
equir
ed.
ed.
ed.
ed.
Installing the hood
Failure to do so can r
Failur
Failur
e to do so can r
e to do so can r
e to do so can result in death or electrical
esult in death or electrical
esult in death or electrical
esult in death or electrical
Failur
Failur
e to do so can r
esult in death or electrical
shock.
shock.
shock.
shock.
shock.
• Remove junction box cover and knockout on the
top left side.
• If not already done, install 1/2" conduit connector
in j-box.
House
wiring
U.L. listed
nut
• Run black (live), white (neutral), and green (earth)
wires (#14 AWG) according to the National
Electrical Code or CSA Standards and local
codes and ordinances in 1/2" conduit from power
supply to j-box.
• Connect black, white, and green wires from
power supply to black, white, and green/yellow
wires in j-box respectively.
• These connections should be done always
making reference to the electrical diagram found
inside the hood.
• Close j-box cover and reapply screws.
Knockout
Junction box
cover
Metal electrical
conduit
11
11
11
11
11