Electrolux IHGL9030CN 사용자 설명서 - 페이지 4

{카테고리_이름} Electrolux IHGL9030CN에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux IHGL9030CN 25 페이지.
Electrolux IHGL9030CN에 대해서도 마찬가지입니다: 사용자 설명서 (17 페이지), 사용자 설명서 (28 페이지)

페이지 인쇄

www.electrolux.com

1. RECOMMENDATIONS

AND SUGGESTIONS

• The Instructions for Use apply

to several versions of this ap-

pliance. Accordingly, you may

find descriptions of individual

features that do not apply to

your specific appliance.

• The manufacturer will not be

held liable for any damages

resulting from incorrect or

improper installation.

• The minimum safety distance

between the cooker top and

the extractor hood is 650

mm (some models can be

installed at a lower height,

please refer to the paragraphs

on working dimensions and

installation).

• Check that the mains voltage

corresponds to that indicated

on the rating plate fixed to the

inside of the hood.

• For Class I appliances, check

that the domestic power sup-

ply guarantees adequate

earthing. Connect the extrac-

tor to the exhaust flue through

a pipe of minimum diameter

120 mm. The route of the flue

must be as short as possible.

• Do not connect the extractor

hood to exhaust ducts carry-

ing combustion fumes (boil-

ers, fireplaces, etc.).

• If the extractor is used in con-

junction with non-electrical

appliances (e.g. gas burn-

ing appliances), a sufficient

degree of aeration must be

guaranteed in the room in

order to prevent the backflow

of exhaust gas. The kitchen

must have an opening com-

municating directly with the

open air in order to guarantee

the entry of clean air. When

the cooker hood is used in

conjunction with appliances

supplied with energy other

than electric, the negative

pressure in the room must not

exceed 0,04 mbar to prevent

fumes being drawn back into

the room by the cooker hood.

• In the event of damage to

the power cable, it must be

replaced by the manufacturer

or by the technical service de-

partment, in order to prevent

any risks.

• If the instructions for installa-

tion for the gas hob specify

a greater distance specified

above, this has to be taken

into account. Regulations

concerning the discharge of

air have to be fulfilled.

• Use only screws and small

parts in support of the hood.

Warning: Failure to install the

screws or fixing device in ac-

cordance with these instruc-

tions may result in electrical

hazards.

• Connect the hood to the mains

through a two-pole switch

having a contact gap of at

least 3 mm.