Atlantic Technology 4.5 LR 사용 설명서 - 페이지 6

{카테고리_이름} Atlantic Technology 4.5 LR에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Atlantic Technology 4.5 LR 8 페이지. High performance ultra-compact home theater loudspeaker system

페이지 인쇄

Models 4.5 LR, 4.5 C, and 4.5 SR

Note: Some surround sound decoders and receivers offer a choice of "normal" or "wide-band" modes for the

center channel. The Model 4.5 C was designed to be used in the "normal" mode. Additionally, some discrete

digital Home Theater systems allow you to select between "Small" and "Large" speakers throughout the

system. Since System 4.5 has been designed only to work with an active subwoofer, you should usually set all

the speaker positions to "Small." However, if you are using the 4.5 PBM subwoofer, please follow the

connection instructions contained in the subwoofer manual.

Surround Effects

The 4.5 SR's size and shape allows greater flexibility in placement than most conventional surround

loudspeakers. Due to their dipole design's spatial characteristics, it is possible to place the speakers

virtually anywhere, but usually the best location is straight out to the sides of, or slightly behind the

primary listening area, approximately 1-2 feet above ear level.

Note: The surround speakers are intended to re-create the ambient sounds taking place in the movie scene.

Throughout most of a movie or TV program you may not be directly aware of the surround speakers presence.

The signals they receive are mostly subtle sounds that should make you believe you're in the movie.

The orientation of the 4.5 SR's is important to the proper generation of the involving and diffuse

surround effect. Mount each speaker on the wall or shelf so that the "direct" soundfield is aimed

toward the front of the room, and the "ambient" soundfield is directed toward the rear. To insure this

orientation, make sure that the RIGHT speaker is on the right side wall of the room, and the LEFT

speaker is on the left side wall of the room. They are marked RIGHT and LEFT on the back.

Music Only System (Model 4.5 LR with subwoofer only)

If you are setting up a music only system, begin with these general guidelines:

The distance between your speakers should be approximately one-half their distance from your

favorite listening position.

Point the front of the speakers straight at you to achieve the most precise imaging. You will also

receive the maximum amount of direct radiated high frequency energy. If you have a "bright" or

"hard" sounding room environment aiming the speakers straight out into the room (or just

aiming them partially towards you) may make for a more natural and pleasing sonic balance.

The distance from each speaker to its three closest room surfaces should be different.

In most rooms, you should not place your speakers in the corners.

The goal is to reproduce accurate musical timbre, and natural sound. Additionally, a well set-up stereo

pair of speakers will create excellent imaging and a cohesive representation of the soundstage.

Placement in the room and your listening position have an enormous impact on the ultimate sound

you will achieve from your system. The most important thing is to be creative! Try placing your

speakers along the long wall instead of the short one. Toe the speakers in or point them straight ahead.

Pull them away from the wall or push them close. Don't be timid. You'll find that moving your

speakers, even a few inches, can dramatically change and possibly improve their sound.