Atlantic Technology IW-30 LCR 사용 설명서 - 페이지 6

{카테고리_이름} Atlantic Technology IW-30 LCR에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Atlantic Technology IW-30 LCR 8 페이지. Thx ultra2 high performance in-wall theater system speaker

페이지 인쇄

Installation

Installing the Speaker

Continue to tighten until the frame is snug in the wall. You want the bezel

to conform to the wallboard, and the frame not to rattle from the speaker's

vibration, but be very careful not to overtighten the screws.

It is strongly recommended that you hand-tighten the mounting screws

the final few turns (after using an electric screwdriver set to "low

torque") to avoid the possibility of damaging the frame.

Painting the Speaker Assembly

The clamping mechanism allows

the wall material to range from

½ to 1½ inches (13 to 38 mm) in

thickness. There must be a mini-

mum depth behind the wall face

of 3

⁄

" (92 mm). Be sure to keep

the edges of the cutout at least

1½inch (38mm) away from any

stud or obstruction, as the rotating

clamps will not operate properly

if you don't. There are holes in the

baffle to allow access to the rotat-

ing clamp screws (see fig below

left). So there is no need to disas-

semble the speaker before instal-

lation. The rotating clamp screws

have a Phillips #2 head.

Insert the speaker assembly

into the cutout and using a level

or square carefully align it so

it is level. Tighten the mount-

ing screws, which will cause the

attached clamps to rotate and

position themselves properly

behind the wall.

The white plastic frame and the

metal grille may be left as is, or

painted to match your décor. You

can paint the frame before or after

it is installed in the wall. Spray

painting (using slightly thinned

paint) is the best method to use for

painting the grille. Before paint-

ing, carefully peel off the scrim

cloth from inside the grille. After

painting the grille, use air pressure

to "blow out" any grille holes that

are filled in with paint, then care-

fully replace the scrimcloth.

Speaker Connection and Assembly

Strip about ½" (13 mm) of insulation from the connecting wires. Connect

them to the appropriate push terminal, being careful to observe polarity

(positive to the red terminal, negative to the black terminal).

A/V Receiver Settings

Most quality A/V receivers provide the option for "small" or "large" front

channel speaker. Choose "small" to get the most out of your IW-30 LCR's

and to prevent possible damage to the speaker.

IW-30 LCR In-Wall Theater System Speaker