Dri-Eaz Dragon K85 Mobile 소유자 매뉴얼 - 페이지 4

{카테고리_이름} Dri-Eaz Dragon K85 Mobile에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dri-Eaz Dragon K85 Mobile 14 페이지. Dri-eaz dragon k85 mobile furnace owner's manual
Dri-Eaz Dragon K85 Mobile에 대해서도 마찬가지입니다: 소유자 매뉴얼 (20 페이지)

페이지 인쇄

only. The internal tank has a 9.3-gallon capacity. Do

not overfill.

Attaching the flue to the Dragon

The Dragon is designed to operate with the flue

attached to the top of the unit. Always operate the

Dragon with the flue attached. In addition to preventing

any water or debris from falling into the heat

exchanger, the flue creates a slight draft on the

Dragon exhaust that assists in preventing thermal

overload.

1. To attach the flue, slide it over the pipe on top of

the heat exchanger.

Attach the flue to the Dragon

2. Drill two 1/8-inch holes through the bottom of the

flue into the heat exchanger pipe. The holes

should be approximately 90 degrees apart.

Drill two 1/8-inch holes in the flue

07-00407F 02/2008

3. Drive a sheet metal screw (#8x1) through each

hole to secure the flue to the Dragon.

Secure the flue to the Dragon with sheet metal screws

Attaching ducting to the Dragon

The Dragon delivers clean heat to a structure through

two 30-foot lengths of 8-inch diameter aluminum

ducting. You must attach both lengths of ducting to the

Dragon for operation.

1. Extend a 1-foot section of ducting and slide a

hose clamp over the end. Slip the ducting over

one of the Dragon outlet duct rings. Secure the

ducting firmly to the duct ring with the hose clamp.

Make sure the clamp is tight enough to hold the

ducting in place when you extend it to the

structure.

Clamp the ducting securely to the duct ring