Atlantic Ultraviolet BIO 3.0 설치 운영 및 유지보수 - 페이지 13

{카테고리_이름} Atlantic Ultraviolet BIO 3.0에 대한 설치 운영 및 유지보수을 온라인으로 검색하거나 PDF를 다운로드하세요. Atlantic Ultraviolet BIO 3.0 16 페이지. Ultraviolet water purifiers

페이지 인쇄

ISPOSAL OF

ERCURY

Germicidal ultraviolet lamps, like standard fluorescent lamps contain small amounts of mercury. Mercury added

lamps should not be placed in the trash. Dispose of properly. For further information regarding the disposal and

recycling of lamps containing mercury, along with Federal and State requirements visit http://www.lamprecycle.org.

Product Data Sheets for germicidal ultraviolet lamps can be found in the "PDF Library for Ster-L-Ray

Ultraviolet Lamps" section of http://www.ultraviolet.com.

TROUBLESHOOTING

WARNING: Always disconnect power to the water purifier before performing any service or maintenance.

IMPORTANT: This unit is to be serviced ONLY by qualified, and appropriately licensed, personnel.

Problem

Purifier not operating

Water leaking into/from purifier.

Poor purifier performance.

. 10-0518A

ALLAST

If power is applied to the ballast without a lamp connected to the circuit or if the lamp fails, the ballast's lamp-out protection

will prevent the ballast from operating, and a red LED light will illuminate and audio alarm will sound. To reset: disconnect the

ballast from power and reconnect or replace the lamp. The ballast must remain disconnected from power for (2) minutes to

reset. After 2 minutes restore input power, ballast should resume proper operation.

WARNING: The equipment that this ballast is used with requires connection to a known good ground. It is the User's

responsibility to insure that their equipment is properly grounded in compliance with the National Electrical Code and

any applicable local codes. Equipment wiring and hook up should be performed by a qualified, licensed electrician.

Failure to comply with this requirement could result in serious injury or death.

DDED

AMPS

Table 3 - Troubleshooting

Possible Cause

No electrical power....

Cracked or broken quartz sleeve...

Quartz sleeve sealing o-ring (s) worn,

damaged...

Poor, or loose, connections or fittings

Quartz sleeve fouled...

Germicidal lamp output depreciating...

Germicidal lamp not functioning...

Low input voltage...

Change in water quality....

10-0514A

AND

HAVE

Corrective Action

Verify that the purifier is connected to a live power

source.

Shut down purifier, drain, and replace quartz

sleeve. See "Quartz Sleeve Installation, Cleaning

or Replacement" or "Replacement of Broken

Quartz Sleeve" in the "Maintenance" section

Shut down purifier, drain, and remove static gland

nut, replace sealing o-ring. See "Quartz Sleeve

Installation, Cleaning or Replacement" in the

"Maintenance" section

Tighten suspect connection or fitting; or shut down

purifier, drain, and remove fitting or connection.

Clean threads; reapply thread sealing tape and

reinstall.

Clean quartz sleeve, see "Quartz Sleeve

Installation, Cleaning or Replacement" in the

"Maintenance" Section.

Replace lamp, as it nears its end of life (EOL).

See "Lamp Installation or Replacement" in the

"Maintenance" section.

Replace lamp. See "Lamp Installation or

Replacement" in the "Maintenance" section

Verify input voltage to purifier.

Have water tested to confirm that it does not

exceed maximum recommended concentration

levels for use with this purifier.

AMP

OUT

ROTECTION

Germicidal