Atlantic Ultraviolet MIN-9 소유자 매뉴얼 - 페이지 5

{카테고리_이름} Atlantic Ultraviolet MIN-9에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Atlantic Ultraviolet MIN-9 16 페이지. Germicidal ultraviolet water purifiers
Atlantic Ultraviolet MIN-9에 대해서도 마찬가지입니다: 소유자 매뉴얼 (16 페이지), 소유자 매뉴얼 (20 페이지)

페이지 인쇄

INSTALLATION

Location

1. The water purifier is intended for indoor use only. The water purifier is designed to mount horizontally. The water purifier

should be protected from the elements and from temperatures below freezing. The ambient temperature, in the area

surrounding the water purifier, should be between 35°F and 100°F.

Electrical power supplied to the water purifier MUST match power requirements listed on the water purifier. Use of a voltage

surge protector is recommended.

into approved ground fault circuit interrupt (GFCI) receptacle. Where a 2-prong or unprotected 3-prong receptacle is

encountered, it must be replaced by a properly grounded Ground Fault Circuit Interrupt (GFCI) receptacle. Installation must

be in accordance with the National Electrical Code and any local codes and ordinances by a qualified electrician.

4. The water purifier should be located in a dry, well-lit area, which provides enough room to perform routine maintenance.

This includes a minimum distance of one chamber length from the chamber end, to allow for cleaning and/or the

changing of the lamp and quartz sleeve as well as a minimum of 6" on the opposite end of the water purifier. Minimum

clearance to floor 18".

5. The water purifier should always be located closest to the point of use. This reduces the chance of the purified water being

re-contaminated by bacteria in the water distribution system after the water purifier.

As with any water handling device, the water purifier should be located in an area where any possible

condensation or leakage from the water purifier, any purifier accessory and/or plumbing will not result in damage to the area

surrounding the water purifier. For added protection, it is recommended that a suitable drain pan be installed under

the purifier. The drain pan must be plumbed to an adequate, free flowing drain to prevent water damage in event of

a leak. There are numerous leak detection/flood stop devices, available on the market today, designed to stop flow

of water, reducing the chance of water damage due to leakage. For more details regarding leak prevention and/or

limiting damages due to leaks please contact factory.

7. The water purifier should be located after all other water devices, such as De-ionizers, Water Softeners, Carbon Filters,

Pre-Filters, Reverse Osmosis, Pressure Tanks, and Pumps. This eliminates the possibility of the purified water being

re-contaminated by bacteria in any of these units.

Recommended Installation

Install water purifier within 48" of a known good ground. Water Purifier will need to be installed

Figure 1 – Recommended Installation