Electrolux PLHV42P8CC 소유자 매뉴얼 - 페이지 4

{카테고리_이름} Electrolux PLHV42P8CC에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux PLHV42P8CC 32 페이지. Range hood
Electrolux PLHV42P8CC에 대해서도 마찬가지입니다: 소유자 매뉴얼 (32 페이지), 소유자 매뉴얼 (11 페이지), 소유자 매뉴얼 (32 페이지), 소유자 매뉴얼 (10 페이지)

Electrolux PLHV42P8CC 소유자 매뉴얼
Installation
FOR RESIDENTIAL USE ONLY
NOT TO BE INSTALLED OVER GAS GRILLS
PLEASE READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING,
INSTALLATION
MUST COMPLY WITH ALL LOCAL CODES,
IMPORTANT: Save these Instructions
for the Local Electrical Inspector's
use.
INSTALLER: Please leave these Instructions with this unit for the owner.
OWNER: Please retain these instructions
for future
reference.
Safety Warning:
Turn off power circuit at the service entrance and lock out
panel, before wiring
this appliance.
Requirement:
120 V AC, 60 Hz. 15 or 20 A
Dimensions
- Table 1
14 3/4
19 I/4
min, 33 13/16
max, 49 1/16
Weight: 86 pounds
Diameter of Transition 8"
Diameter of exhaust Duct required 8"
42"
Figure
I *
271'
Note: All dimensions are shown in inches.
* Dimensions are given from base of hood to ceiling, and include clearance
required for installation.
Considerations
before
installing
Hood
1.
For the most efficient air flow exhaust, use a straight run or as few elbows as
possible.
CAUTION:
Vent unit to outside of building, only.
2.
If allowed in your area, use metallic flex ducting only to connect rigid duct
directly to transitions.
3.
COLD WEATHER installations should have an additional backdraft damper
installed to minimize backward cold air flow and a nonmetallicthermal
breakto
minimize conduction of outside temperatures as part of the ductwork.
The
damper should be on the cold air side of the thermal break. The break should
be as close as possible to where the ducting enters the heated portion of the
house.
4.
Hood installation heightabove cooktop isspecified in Figure2. Be surethatyour
hood model fits your installation.
4