Electrolux RH30WC55GS 설치, 사용 및 관리 매뉴얼 - 페이지 12

{카테고리_이름} Electrolux RH30WC55GS에 대한 설치, 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux RH30WC55GS 21 페이지. 30” et 36” hotte aspirante
Electrolux RH30WC55GS에 대해서도 마찬가지입니다: 공장 부품 카탈로그 (4 페이지), 브로셔 및 사양 (2 페이지), 설치, 사용 및 관리 매뉴얼 (20 페이지), 설치, 사용 및 관리 매뉴얼 (20 페이지), 설치, 사용 및 관리 매뉴얼 (20 페이지), (영어) 설치, 사용 및 관리 가이드 (25 페이지), (프랑스어) 설치, 활용 및 사용 설명서 (21 페이지)

Installing the hood

Making the electrical connections

Electrical Shock Hazard

Warning: Turn off power at the service panel before

wiring this unit.

120 V AC, 15 or 20 Amp circuit required.

ELECTRICAL GROUNDING INSTRUCTIONS

THIS APPLIANCE IS FITTED WITH AN

ELECTRICAL JUNCTION BOX WITH 3 WIRES,

ONE OF WHICH (GREEN/YELLOW) SERVES TO

GROUND THE APPLIANCE. TO PROTECT YOU

AGAINST ELECTRIC SHOCK, THE GREEN AND

YELLOW WIRE MUST BE CONNECTED TO THE

GROUNDING WIRE IN YOUR HOME

ELECTRICAL SYSTEM, AND IT MUST UNDER

NO CIRCUMSTANCES BE CUT OR REMOVED.

Failure to do so can result in death or electrical

shock.

Remove junction box cover and knockout on the

top left side.

Knockout

Junction box

cover

If not already done, install 1/2" conduit connector

in j-box.

NOTE: This connector is not included with vent

hood.

House

wiring

UL listed

wire nut

Run black (live), white (neutral), and green (earth)

wires (#14 AWG) according to the National

Electrical Code or CSA Standards and local

codes and ordinances in 1/2" conduit from power

supply to j-box.

Connect black, white, and green wires from

power supply to black, white, and green/yellow

wires in j-box respectively.

These connections should be done while always

making reference to the electrical diagram found

inside the hood.

Close j-box cover and reapply

Metal electrical

conduit