Electrolux RH30WC60GSA 설치, 관리 및 사용 설명서 - 페이지 19
{카테고리_이름} Electrolux RH30WC60GSA에 대한 설치, 관리 및 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux RH30WC60GSA 21 페이지. 30" and 36" free standing range hood
Electrolux RH30WC60GSA에 대해서도 마찬가지입니다: 공장 부품 카탈로그 (4 페이지), 공장 부품 카탈로그 (4 페이지), 부품 카탈로그 (4 페이지)
페이지 인쇄
Care and cleaning
Care and cleaning
The efficiency of the range hood system depends on
the cleanliness of the intake and filters.
The frequency of cleaning depends on the amount
and type of cooking.
•
Do not use the ventilating system without the
filters in place or with grease-laden filters or
surfaces.
To avoid risk of fire and explosion do not use
flammable liquids or solvents.
Always unplug or disconnect the appliance from the
power supply before servicing.
Be sure the entire hood (including the filters and light
bulbs) has cooled and grease has solidified before
attempting to clean any part of the appliance.
Filters
The metal grease filters are made of stainless steel
anodized aluminum and are long lasting.
To Remove The Metal Grease Filters
Turn the fan and lights off.
Pull the spring release handle.
Lights
Before replacing the lamps, switch power off at
service panel and lock service panel disconnecting
means to prevent power from being switched on
accidentally.
NOTE:
-rum off the lights and fan. Allow the lights
to cool before handling. If new lights do not
operate be sure lights are inserted correctly before
calling service.
Replace Lights
Remove the inner lamp lens cover by inserting a
small flat blade screwdriver into each of the three
slots and gently prying it free.
NOTE: Do not remove the outer trim ring (lamp
assembly).
Grasp the bulb and pull it straight out.
Replace with 12 volt, 20 watt halogen bulbs with
a G4 base SUITABLE FOR USE IN OPEN
LUMINAIRES.
Follow package directions, wear gloves, do not
touch bulb with your bare fingers.
To Replace The Metal Grease Filters
Reverse procedure.
To Clean Filters
o
It is recommended that the filters be washed at
least once a month; they can be washed by hand
or in the dishwasher.
Drain water through edge holes and let each filter
dry thoroughly before replacing it.
Replace inner cover by insertingthe three
retaining tabs into the three slots and pressing
them firmly in place.