Electrolux RH36PC60GSB 사용 및 관리 매뉴얼 - 페이지 12

{카테고리_이름} Electrolux RH36PC60GSB에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux RH36PC60GSB 42 페이지. 36" and 42" island range hood
Electrolux RH36PC60GSB에 대해서도 마찬가지입니다: 설치, 사용 및 관리 매뉴얼 (21 페이지)

페이지 인쇄

Installing the hood

iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii

iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii

_lllllllllllllllllllllllllllllllllllllllllllllllllllllllllllllllllllllllllllllll

Ceiling ducting

Use the template

previously

installed to prepare a

8 - t/2" hole in the ceiling for ductwork.

5()'

_ax

(:Xt@Yi! iOYi

10' = 1 20"

Ceiling

Height

35"

(Minimum

Installation

Height)

TO PROTECTYOU AGAINST ELECTRICSHOCK,

THE GREENAND YELLOW WIRE MUST BE

CONNECTED TO THE GROUNDING WIRE IN

YOUR HOME ELECTRICALSYSTEM, AND IT MUST

UNDER NO CIRCUMSTANCES BE CUT OR

REMOVED.

Failure to do so can result in death

or electrical shock.

Remove junction box cover and knockout on the

top left side.

Knockout

Junction box

cover

When the Island is installed in a 10' Ceiling,

35" is the closest distance we can have from

the cooking surface. 35" is the recommended

height

;::_ 0" n_in

_Xt@nSiO

Y/i

8' = 96"

Ceiling Height

3o" (Maximum

nstallation

Height)

When the Island is installed in an 8' Ceiling, 30" is

the longest distance we can have from the cooking

surface. 30" is the recommended

height 24" - 30" for

electrical cooking surface

Making the electrical connections

Electrical Shock Hazard

Warning: turn off power at the service panel before

wiring this unit.

120 V AC, 15 or 20 Amp circuit required.

ELECTRICAL GROUNDING INSTRUCTIONS

THIS APPLIANCE IS FI-I-rED WITH AN ELECTRICAL

JUNCTION BOX WITH 3 WIRES, ONE OF WHICH

(GREEN/YELLOW) SERVES TO GROUND THE

APPLIANCE.

If not already done, install 1/2" conduit connector

in j- box.

NOTE: This connector is not included with vent hood.

Metal electrical

conduit

House

wiring

UL listed

wire nut

Run black (live), white (neutral), and green (earth)

wires (# 14 AWG) according to the National

Electrical Code or CSA Standards and local

codes and ordinances in 1/2" conduit from power

supply to j- box.

Connect black, white, and green wires from

power supply to black, white, and green/yellow

wires in j - box respectively.

These connections should be done always

making reference to the electrical diagram found

inside the hood.

Close j - box cover and reapply screws.