Electrolux RH36PC60GSB 사용 및 관리 매뉴얼 - 페이지 18

{카테고리_이름} Electrolux RH36PC60GSB에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux RH36PC60GSB 42 페이지. 36" and 42" island range hood
Electrolux RH36PC60GSB에 대해서도 마찬가지입니다: 설치, 사용 및 관리 매뉴얼 (21 페이지)

페이지 인쇄

Care and cleaning

_lllllllllllllllllllllllllllllllllllllllllllllllllllllllllllllllllllllllllllllll

iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii

_lllllllllllllllllllllllllllllllllllllllllllllllllllllllllllllllllllllllllllllll

The efficiency of the range hood system depends on

the cleanliness of the intake and filters.

The frequency of cleaning depends on the amount

and type of cooking.

Do not use the ventilating system without the

filters in place or with grease-laden filters or surfaces.

To avoid risk of fire and explosion do not use

flammable liquids or solvents.

Always unplug or disconnect the appliance from the

power supply before servicing.

Be sure the entire hood (including the filters and light

bulbs) has cooled and grease has solidified before

attempting to clean any part of the appliance.

Filters

The metal grease filters are made of anodized

aluminum and are long lasting.

To Remove The Metal Grease Filters

Turn the fan and lights off.

Pull the spring release handle.

Lights

Before replacing the lamps, switch power off at

service panel and lock service panel disconnecting

means to prevent power from being switched on

accidentally.

NOTE:

Turn off the lights and fan. Allow the

lights to cool before handling.

Replace lights

per instructions.

If new lights do not operate,

be sure lights are inserted correctly before

calling service.

Replace Lights

•

Remove the inner lamp lens cover by inserting a

small flat blade screwdriver into each of the three

slots and gently prying it free.

NOTE: Do not remove the outer trim ring (lamp

assembly).

Inner

ring

Outer

ring

To Replace The Metal Grease Filters

Reverse procedure.

To Clean Filters

It is recommended that the filters be washed at

least once a month; they can be washed by hand

or in the dishwasher.

Drain water through edge holes and let each filter

dry thoroughly before replacing it.

The glass lens and inner trim ring are 2 pieces

loose fitting. Be careful when removing the trim

ring that the glass lens does not fall out.

•

Grasp the bulb and pull it straight out from the

lamp socket.

•

Replace with 120 volt, 40 watt halogen bulbs with

a G9 base SUITABLE FOR USE IN OPEN

LUMINAIRES.

Follow package directions, wear gloves, do not

touch bulb with your bare fingers.

Bulb

•

Replace inner cover by

inserting the three

retaining tabs into the

three slots and pressing

them firmly in place.

NOTE: Once you have replaced the light bulb,

make sure to put back the glass in its place.