Electrolux U24211 EFT 535 작동 및 설치 지침 - 페이지 7

{카테고리_이름} Electrolux U24211 EFT 535에 대한 작동 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux U24211 EFT 535 15 페이지. Electrolux range hood operation and installation manual

페이지 인쇄

Paper grease filter (EFT 630-530)

• The purpose of the grease filters is to absorb

grease particles which form during cooking and

it must always be used, either in the external

evacuation or internal recycling function.

The paper grease filter is very thin (approx. 1

mm) and positioned on the inside of its related

support grille.

The filter should be changed once a month.

• The grille should be cleaned with luke warm

water and non-abrasive detergent when you

change the filter.

• The grease filter can be ordered from your local

Electrolux Service Force Centre.

• Opening the grille

Open the latch and swing the grille downwards.

To remove the grille, pull it forwards from the

right and release it.

Removing the filter

Open the grille and remove the stops to take

out the filter.

Charcoal filter

• The charcoal filter should only be used if you

want to use the hood in the recirculation

function.

• To do this you will need an original Electrolux

charcoal filter (available from your local

Service Force Centre).

• The charcoal filter cannot be washed nor

regenerated.

The charcoal filter should be replaced every 12

months under normal use.

Replacement filters are available from your

local Service Force Centre.

Fitting

Remove the cover by rotating the knobs to 90°,

put the charcoal filter inside and fix it by

rotating the knob to 90° then close the cover.

• To remove proceed in the reverse order.

• Always specify the hood model code number

and serial number when ordering replacement

filters. This information is shown on the

registration plate located on the inside of the

unit.

• The charcoal filter can be ordered from your

local Electrolux Service Force Centre.

Changing the light bulb

• Disconnect the cooker hood from the mains

supply.

• Remove the grid or the metal grease filter.

• Replace the old bulb with a new one of the

same type.

• Remount the grid or the metal grease filter.

• If the light does not come on, make sure the

bulb has been inserted correctly before

contacting your local Service Force Centre.

Latch

Grille

Fig. 5 - Paper Grease filter

Knobs

Move the lever

to position F

Fig. 6 - Charcoal Filter - Fitting

Latch

Grease

filter

Stops

knob

Cover

Charcoal filter