Electrolux WHGL9030CN 사용자 설명서 - 페이지 6

{카테고리_이름} Electrolux WHGL9030CN에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux WHGL9030CN 28 페이지.
Electrolux WHGL9030CN에 대해서도 마찬가지입니다: 사용자 설명서 (29 페이지), 설치 매뉴얼 (12 페이지), 설치 매뉴얼 (12 페이지)

페이지 인쇄

www.electrolux.com

4. CONTROLS

Button

L T1 T2 T3 T4 T5 F

Basic function

Dual Function

Press briefly to turn the lighting system on and off.

Press and hold the button for 2 seconds to activate

the lighting system in "courtesy light" mode. The lights

are lit at a reduced power of approximately 5W. This

function can be disabled by pressing the button once

again for 2 seconds or by pressing it briefly to switch

to normal lighting mode.

Turns the motor off from whatever speed it is set to.

Press and hold the button for 3 seconds with all the

loads turned off (Motor and Lights), to turn the Activated

Charcoal Filter alarm on/off.

Turns the motor on at speed one.

When pressed briefly, turns the motor on at speed two. Button on.

Press and hold the button for approximately 2" to turn

the Delay function on and off, that is to say to turn the

appliance off after a 20 minute delay. Suitable to complete

elimination of residual odours. Can be activated from

the OFF position and from speeds 1, 2, 3. Cannot be

activated with Intensive speed On.

Turns the motor on at speed three.

Turns the motor On and Off at Intensive speed for a

timed period of 5 minutes. At the end of the 5 minutes

the appliance will automatically return to the speed

that was set before. If the appliance was turned off at

the time of activation, at the end of the 5 minutes the

system will return to speed one.

Press and hold for 4 seconds to reset the filter alarm

indicator, shown by flashing of button T1. This procedure

can only be carried out with the motor off.

Indicator lights

Button off.

Lights off.

Button lit.

Lights on.

Button lit.

Courtesy light on.

Button lit.

Motor active.

Motor inactive.

Button flashes twice F – Alarm On.

Button flashes once F – Alarm Off.

Button on.

Speed two on.

Buttons flashing

(T1+T2 or T3

Delay functionActive.

or T4).

Button on.

Signals the Metal Grease

Filter saturation alarm, indi-

cating that it is necessary to

Button on

wash the filters. The alarm

is triggered after the Hood

has been in operation for

100 working hours.

When this is activated, it sig-

nals the Activated Charcoal

Filter saturation alarm, indi-

cating that the filter must be

changed; the Metal Grease

Button flashing

Filters must also be washed.

The Activated Charcoal Filter

saturation alarm comes into

operation after the Hood has

been working for 200 hours.