Electrolux 900258442 지침서 - 페이지 12

{카테고리_이름} Electrolux 900258442에 대한 지침서을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux 900258442 29 페이지. Bagless canister vacuum cleaner

페이지 인쇄

TIPS ON HOW TO GET THE BEST RESULTS

NOZZLE/ACCESSORY

K. 3in1 accessory tool*

W. Turbo nozzle*

Y. ParkettoPro nozzle*

AA. Long crevice nozzle*

Models with manual power regulation

– follow graphics on cleaner for optimal performance.

TROUBLESHOOTING

PROBLEM

The vacuum cleaner does not start

The cleaner stops

Reduction of suction capacity versus

normal

Water has been sucked into the vacuum

cleaner

For any further problems, contact an authorized Electrolux service centre.

USE FOR:

3 tools in 1:

1. Dusting tool for hard surfaces

(bookshelves, skirting boards etc).

2. Upholstery tool for textiles

(curtains, upholstery etc).

3. Crevice tool for narrow spaces

(behind radiators etc).

Carpet nozzle:

- Brushes and vacuums at the same

time (best pick up of hair, fibres

etc).

- Brush roller is driven by the airflow

of the vacuum cleaner.

- Not suitable for carpets with very

deep piles and long fringes, anti-

slip carpets like door mats or water

resistant carpets. Use universal

nozzle instead.

Hard floor nozzle:

- For gentle cleaning of hard floor

(parquet, wooden floor, tiles etc).

- Best dust pick up on hard floor

with crevice.

Extra long tool:

- For areas hard to reach (top of

shelves etc).

- For narrow spaces (behind

radiators, under car seats etc).

SOLUTION

• Check that the cable is connected to the mains.

• Check that the plug and cable are not damaged.

• Check for a blown fuse.

• Check if the battery indicator lamp in the remote control handle responds (certain models only).

The cleaner might be overheated: disconnect it from the mains; check if the nozzle, tube, hose or filters

are blocked. Let the cleaner cool down for 120 minutes before plugging it in again.

If the cleaner still does not work, contact an authorized Electrolux service centre.

• Check if the dust compartment is full or blocked.

• Check if the air channel and inlet or outlet connection is blocked and needs to be cleared.

• Check if the pre-motor filter is clogged and needs changing.

• Check if nozzle is blocked and needs to be cleared.

• Check if hose is blocked by squeezing it gently. However, be careful in case the obstruction has been

caused by glass or needles caught inside the hose.

Note: The warranty does not cover any damage to the hose caused by cleaning it.

It will be necessary to replace the motor at an authorized Electrolux service centre.

Damage to the motor caused by the penetration of water is not covered by the warranty.

NOZZLE/ACCESSORY

USE FOR:

U. FlowMotion nozzle*

Universal nozzle:

V. FlowMotion LED

- For all floor types, secures best dust pick

nozzle*

up on both carpets and hard floors.

- Change nozzle setting with the pedal.

Icon will show recommended floor type.

- Front light helps to detect dust and

dirt in dark spaces (under furniture etc).

PureVision only

X. Mini Turbo nozzle*

Upholstery nozzle:

- Brushes and vacuums at the same time

(best pick up of hair, fibres etc).

- For textile furniture, car seats, mattresses

etc.

- Brush roller is driven by the airflow of the

vacuum cleaner.

- Not suitable for carpets with very deep

pile and long fringes as it can get stuck in

the rotating brush roll.

Z. FlexProPlus nozzle*

Hardfloor nozzle:

- For reach under/between furniture,

corners and other obstacles.

- Can easily turn 180 degrees for direct

access to narrow spaces.