Electrolux Beam 설치 매뉴얼 - 페이지 11

{카테고리_이름} Electrolux Beam에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux Beam 16 페이지. Central

THE PIPE/DUCTWORK:

The pipe has a 52mm (2") outside diameter and comes in 2m lengths. With

each inlet kit you would normally get 6m of pipework, which is what we've

calculated is the average requirement.

Cut the pipe at a 90° angle using a simple mitre-block with a hand saw.

DE-BURR edges with sandpaper so they are clean and smooth. Doing this

will ensure nothing you suck-up will catch on any rough edges.

Alternatively, you can purchase a special pipe cutter from us - saving you

time on cuts and de-burring. Call us on 0845 260 0123 for details.

INSTRUCTIONS FOR CUTTING WITH PIPE-CUTTER (purchase separately)

Should you need more pipe to be delivered, just contact us. If you only

require one more length of pipe (2m), we can cut the pipe in two for you

and send it in the post! (Just make sure you have a coupler left though.)

RULE 1

1: Slide the

cutter over

the end of

the pipe.

3: Separate

the pipe.

CLEAN

CUT EDGES

2: At the

point you

wish to cut,

engage the

blade and

rotate the

cutter at

least twice

around the

pipe.

4: The end is

cut to a

smooth

finish.