Atlantis NetFly A02-AP1-W54 빠른 시작 매뉴얼 - 페이지 8

{카테고리_이름} Atlantis NetFly A02-AP1-W54에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Atlantis NetFly A02-AP1-W54 15 페이지. Wireless multi-function access point

페이지 인쇄

Before Configuration

This section describes the configuration required by LAN-

attached PCs that communicate with the Wireless Multi-

Function Access Point, either to configure the device or for

network access. These PCs must have an Ethernet interface

(or wireless adapter) installed properly, be connected to the

Wireless Multi-Function Access Point either directly or

through an external repeater hub or by wireless, and have

TCP/IP installed and configured with a fixed IP address that

must be in the same subnet of the Wireless Multi-Function

Access Point. The default IP address of the Wireless Multi-

Function Access Point is 192.168.1.1 and subnet mask is

255.255.255.0. For example, when the default network

address of the default IP address of the AP is 192.168.1.1,

then the manager PC should be set at 192.168.1.x (where x

is a number between 2 and 254), and the default subnet

mask is 255.255.255.0.

Please follow the steps below for PC's network environment

installation. First of all, please check your PC's network

components. The TCP/IP protocol stack and Ethernet

network adapter must be installed. If not, please refer to MS

Windows related manuals.

Before you configure this Wireless Multi-Function Access

Point, you need to know the following default settings:

•

Username:admin

•

Password:admin

•

IP LAN address: (192.168.1.1), Subnet Mask

(255.255.255.0)

•

DHCP Server: disable

•

SSSID= default, Channel=6, WEP/WAP=disable

1.6 IE Configuration

Now open IE, go to Instruments menu, select the

Connections tab and select one of the following options:

NetFly AP1-54