Electrolux Beam Alliance 운영 매뉴얼 - 페이지 6

{카테고리_이름} Electrolux Beam Alliance에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux Beam Alliance 13 페이지. Central vacuum system
Electrolux Beam Alliance에 대해서도 마찬가지입니다: 운영 매뉴얼 (36 페이지), 운영 매뉴얼 (16 페이지)

페이지 인쇄

Muffler Installation

The muffler is installed to the exhaust located at the rear

of the power unit using the 3 ttings provided and Torx 20

screws provided. We suggest you install your muffler as

shown, prior to hanging your Power Unit (Although some

modi cation to this is acceptable), (Figure 4).

NOTE: Do not install muffler on the same side as the

intake ange so as to not interfere with pipe intake. Insert

the 90 degree tting into the muffler and screw into place.

Glue the next two ttings in place before connecting to the

power unit. Use the Torx 20 screws provided to connect

muffler to Power Unit.

NOTE: Do not glue the muffler pipe to the central vacuum

unit.

Figure 4

HEPA Filter Installation (optional)

Use the Torx 20 screws to secure the 90 degree

elbow provided to the HEPA lter. Use screws

to connect HEPA lter to Power Unit. We

recommend you install the HEPA lter before

hanging your Power Unit. (Figure 5a)

NOTE: Do not glue the HEPA lter to the

central vacuum unit.

NOTE: One elbow must be installed if the

muffler or the HEPA lter is not used. (Figure 5b)

Figure 5b

Figure 5a

BASIC OPERATION FOR BEAM ALLIANCE POWER UNIT

To operate, simply plug the hose into one of the handy wall inlet valves. The metal ring on the hose cuff will

complete a low-voltage electrical circuit, which in turn activates a relay and turns on the system's power unit. To

turn off the power unit, simply unplug the hose from the inlet.

Note: When unplugging the hose, it is recommended to hold the inlet door open for a few seconds until the

suction pressure has sufficiently decreased.

For safety purposes, a low-voltage circuit is utilized at the wall inlet. The power unit functions on a standard

110/120-volt circuit. There are optional hoses available with an on/off switch located on the handle.

Note: When using one of these optional hoses, it is important to properly align the hose with the wall inlet when

plugging it in to prevent damage to the unit.