Electrolux Cyclone Power ZSH720 소유자 핸드북 매뉴얼 - 페이지 5
{카테고리_이름} Electrolux Cyclone Power ZSH720에 대한 소유자 핸드북 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux Cyclone Power ZSH720 8 페이지. Cylinder vacuum cleaners
페이지 인쇄
8 Press the on/off switch (5) to switch the
vacuum cleaner on. On initial start up,
full power is reached after approximately
1-2 seconds. See fig. 8.
9 Adjust the suction power by rotating the
variable power control (3) or by sliding
the suction control on the hose handle.
See fig. 9.
10 To rewind the cable, press the cable
rewind button (4) with one hand and
guide the cable with the other hand to
ensure that it does not whip which can
cause damage or injury. See fig. 10.
11 Store the vacuum cleaner in the parking
position. An accessory clip is situated on
the back of the machine and on the dual
purpose floor nozzle (11). These can
be used to park the floor tool. See fig. 11.
NOTE: Before doing any type of cleaning
or maintenance to the vacuum cleaner,
remove the plug from the mains supply.
Always operate the vacuum cleaner with the
dust container (7) installed. It is normal for
the dust container indicator (2) to activate
whilst using the cleaner, Therefore before
Fig. 8
you commence cleaning, turn the cleaner
on without the tools attached, if the indicator
remains activated then check the air inlet
channel of the cleaner. If it is clogged clear
it. See fig. 12. If the dust container indicator
still remains activated after clearing check
the cartridge filter (15).
Fig. 9
Emptying the dust container:
1 Remove the dust container (7) from the
vacuum cleaner. See fig. 13.
Fig. 10
2 Remove the filter set from the dust
container (7) by lifting the white lid off
the dust container (7). See fig. 14.
Fig. 11
5
HOW TO CLEAN THE
DUST CONTAINER
Fig. 12
Fig. 13
Fig. 14