Drill Master 60625 사용 설명서 및 안전 지침 - 페이지 17

{카테고리_이름} Drill Master 60625에 대한 사용 설명서 및 안전 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Drill Master 60625 20 페이지. 120 volt 4-1/2" angle grinder
Drill Master 60625에 대해서도 마찬가지입니다: 소유자 매뉴얼 (20 페이지)

페이지 인쇄
Drill Master 60625 사용 설명서 및 안전 지침

Troubleshooting

Problem
Tool will not start.
Tool operates slowly. 1. Excess pressure applied to workpiece.
Performance
decreases over time.
Excessive noise
or rattling.
Overheating.
Tool does not
grind, sand or
brush effectively.
Follow all safety precautions whenever diagnosing or servicing
the tool. Disconnect power supply before service.
Item 60625
Downloaded from
www.Manualslib.com
Possible Causes
1. Cord not connected.
2. No power at outlet.
3. Tool's thermal reset
breaker tripped (if equipped).
4. Internal damage or wear. (Carbon
brushes or switch, for example.)
2. Power being reduced by long or
small diameter extension cord.
Carbon brushes worn or damaged.
Internal damage or wear.
(Carbon brushes or bearings, for example.)
1. Forcing tool to work too fast.
2. Blocked motor housing vents.
3. Motor being strained by long or
small diameter extension cord.
1. Disc accessory may be
loose on Spindle.
2. Disc accessory may be damaged,
worn or wrong type for the material.
For technical questions, please call 1-800-444-3353.
manuals search engine
Likely Solutions
1. Check that cord is plugged in.
2. Check power at outlet. If outlet is unpowered,
turn off tool and check circuit breaker.
If breaker is tripped, make sure circuit is right
capacity for tool and circuit has no other loads.
3. Turn off tool and allow to cool.
Press reset button on tool.
4. Have technician service tool.
1. Decrease pressure, allow tool to do the work.
2. Eliminate use of extension cord.
If an extension cord is needed, use one with
the proper diameter for its length and load.
See Extension Cords in GROUNDING section.
Have qualified technician replace brushes.
Have technician service tool.
1. Allow tool to work at its own rate.
2. Wear ANSI-approved safety goggles and
NIOSH-approved dust mask/respirator while
blowing dust out of motor using compressed air.
3. Eliminate use of extension cord.
If an extension cord is needed, use one with
the proper diameter for its length and load.
See Extension Cords in GROUNDING section.
1. Be sure disc accessory arbor is correct
and Outer Flange/Arbor Nut is tight.
2. Check condition and type of disc accessory.
Use only proper type of disc
accessory in good condition.
Page 17