Atlas PM Series 설치 지침 매뉴얼 - 페이지 19

{카테고리_이름} Atlas PM Series에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Atlas PM Series 19 페이지. Pedant mount loudspeakers 4" and 8"
Atlas PM Series에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (12 페이지)

페이지 인쇄
Atlas PM Series 설치 지침 매뉴얼
Troubleshooting
PROBLEM
There is no sound
There is no sound
Low sound level
Sound cuts in and out
Distortion at increased levels
Speaker makes "buzzing"
noise
1601 JACK MCKAY BLVD.
ENNIS, TEXAS 75119 U.S.A.
PM Series
Pendant Mount Loudspeakers
POSSIBLE CAUSE
Power off. Equipment setting is wrong.
Volume set too low.
Loose connection.
Setting/volume control is set too low.
Connection is shorted or bad.
System overload/oscillation intermittent
connection.
Amplifier/speaker overdriven.
Hardware loose or speaker damaged.
REMEDY
Assure that power is applied to all equipment in system.
Check that routing (input/output) controls are set correctly.
Check that volume level is above minimum.
Check system from start to finish for crossed wires, loose
connection, etc. On the PM location check for correct
connection.
Check volume levels or amplifiers and related equipment
(equalizer). Check that connections aren't partially shorted/
corroded.
Check for overload condition or bad connection.
Check that power to speaker isn't over limits. Check that
amplifier isn't overdriven. Reduce power to amplifier slightly.
Make sure speaker grille is tight. Check other hardware
connections. Check speakers for loose parts or speaker
damage.
TELEPHONE: (800) 876-3333
FAX (800) 765-3435
7/7
AtlasSound.com