Atlas TSD-ML22VCA 소유자 매뉴얼 - 페이지 4

{카테고리_이름} Atlas TSD-ML22VCA에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Atlas TSD-ML22VCA 9 페이지. 2x2 mic/line preamp & vca

2x2 Mic/Line Preamp & VCA

Rear Panel Description

TSD Input/Output connections are removable for easy system wiring. The connector has a 3.5mm

pitch between pins.

1. DC Power Input - Each TSD that requires DC power comes with a 2 position connector for

an external 24VDC power supply (sold separately). Because of the TSD's low power consumption,

a single external power supply may power more than one TSD. Please refer to the specifications

on current requirements in milliamps to match with the appropriate power supply. Note: It is

acceptable to exceed the current requirements of the TSDs but NOT safe to use a power supply

that is below the current requirement of the device.

2. Balanced Mic/Line Input 1-2 - Connects to balanced line or mic level sources. Your connection

must be mated properly to the input connector or signal loss and/or noise may occur. For gain or

source input type selection, refer to the "Dip Switch Function Identification" chart for proper

input setting. Note: Unbalanced line level inputs can be inserted with proper wire configuration by

connecting the (G) and (-) terminals together.

3. Balanced Mic/Line Output 1-2 - Provides output when an input signal is present for connection

to balanced mic or line level devices. Your output connections must be connected properly to

the connectors or loss and/or noise may be introduced into the signal. For gain or source input

type selection, refer to the "Dip Switch Function Identification" chart for proper output setting.

Note: Unbalanced line level devices can be used with proper wire configuration by connecting the

(G) and (-) terminals together.

4. VCA - Remotely control the audio levels via VCA technology. Connect one side of a 10K linear taper

pot to the terminal marked DC10V, the other side of the pot to the (G) terminal, and the wiper to the

Control 1 terminal. Set the switch to the correct channel terminal. Control 1 will adjust input

channel 1 and Control 2 will adjust input channel 2.

5. Cable Management Retainer Points - Each TSD includes two cable retainer straps for securing

the included cable management retainers. Remove one of the rear panel screws, align the

panel hole with a retainer and firmly tighten the screws.

AtlasSound.com

TSD-ML22VCA

1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.

Telephone: 800.876.3333 • Fax: 800.765.3435

– 4 –

Specifications are subject to change without notice.

Owner's Manual