AirTechnic ENERGY BOX - TO 1.400 조립 및 유지보수 매뉴얼 - 페이지 17
{카테고리_이름} AirTechnic ENERGY BOX - TO 1.400에 대한 조립 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AirTechnic ENERGY BOX - TO 1.400 20 페이지. Ceiling type heat recovery unit (aluminium plate)
페이지 인쇄CONTROL PANEL (Models For Electric Heater)
MODE
FAN
FAN
HIGH
MED
COOL
LOW
HEAT
EXHA UST F AN
SUPPLY FAN
AUTO
VOD
RUN/ST OP
MODE
FAN SPEED
HRV
FAN
With this button the fan speed of the exhaust and supply fan can be changed.
*
Pressing once: text FAN lights up. "EXHAUST FAN" and current fan speed (text) starts blinking
*
Use
*
Press OK to confirm
"SUPPLY FAN" and current fan speed (text) starts blinking
*
*
Use
Press OK to confirm
*
*
Text FAN and HIGH, MED, LOW lights up
TIMER
Press to set timer function on/off. When "on" the display shows SET
RESET
Press to reset filter check. When "on" the display shows FILTER CHECK.
Default Filter Check the value in use in parameter list 2.3.3.
MODE
FAN
COOL
HEAT
AUTO
VOD
Shows active mode
of operation
+30.211.70.55.500
MON TUE WED THU FRI S AT
SET TEMP
SUN SET
25°C
12.00
BY-PASS
FILTER
FUNC TION
CHECK
TIMER
RESET
DAY
SCHEDULE
SELEC T
buttons to select fan speed (high, med, low)
buttons to select fan speed (high, med, low)
Only visible when
changing fan speed
FAN
HIGH
MED
LOW
EXHAUST FAN
Shows actual fan speed of
supply and exhaust fan
+30.210.22.23.283
RUNSTOP
When the backlight and led is off, press the button
once to turn the unit on.
When the unit is "on" press on / off 2 seconds to
switch it off.
Increase / decrease set point room tempreature
(SET TEMP is on)
MODE
Press to select the listed modes of operation (FAN, COOL,
OK
HEAT, AUTO, VOD). Every time button is pressed, next mode lights
up. After a 5 seconds delay the mode will be activated. The text
MODE on display is always visible.
Shows
current day
MON TUE WED THU FRI SAT SUN
SET
SUPPLY FAN
Lights up when
By-Pass is open
Actual r oom temp or
Actual time or
set point
timer block s
SET TEMP
25
12.00
FILT ER
BY - PASS
CHECK
FUNCTION
Lights up when filters
should be checked
0
C
17