Atlas Copco 8431080042 제품 지침 - 페이지 11

{카테고리_이름} Atlas Copco 8431080042에 대한 제품 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Atlas Copco 8431080042 16 페이지.

페이지 인쇄

LTP61 H700-25

Inspection

After the cleaning, inspect all parts. Damaged and worn parts should be replaced.

Lubrication Instructions

Rust protection and cleaning

Water in the compressed air can cause rust. To prevent rust we strongly recommend to install an air dryer.

Water and particles can cause sticking of vanes and valves. This can be prevented by installing an air fil-

ter close to the product to avoid pressure drop.

Before longer standstills always protect your tool by adding a few drops of oil into the air inlet. Run the tool

for 5–10 seconds and absorb any access oil at the air outlet in a cloth.

Lubrication guide

Brand

Castrol

Esso

Mobil

Klüber Lub.

Texaco

Molykote

* Not for angle gears.

Brand

Molykote

For maximum performance

At tough working conditions – soft joints and max. setting – lubrication of the air is recommended.

With extreme dry air the service life of vanes and machine performance might be reduced. A daily supply

of 0.1 – 0.2 ml oil into the machine inlet will improve the machine performance. Alternatively consider an

automatic lubricator device, Atlas Copco oil fog lubricator DIM, or single point lubricator DOS, which will

improve the machine performance.

Dismantling/Assembling Instructions

Assembly

Remove silencer and air nipple. Then completely remove the old Rubber cover. Fix the Motor casing in a

vice. To easy the assembly put some soap-water mixture on the new Rubber cover ends. Make a loop of

a heawy duty strap and then put the loop of strap through the Rubber cover and then around the Handle,

see illustration 1 below. Pull on strap until Rubber cover is completely over the lower part of handle.

Gluing

When cover is in correct position clean the ends of cover from soap. Then carefully apply glue (Loctite

406) on the inside around edges and in the middle of cover, see illustration 2 below. It is especially impor-

tant that the surface near the trigger is carefully coated with glue. Press Rubber cover so it fits nice and

thight, see illustration 3 below.

General purpose, Bearings and Gears*

Energrease LS-EP2

OBEEn UF 1

Beacon EP2

Rembrandt EP2

Mobilegrease XHP 222 NLG 2

Klübersynth UH 1 14-151

Multifak EP2

BR2 Plus

Angle gears

Longterm 2 Plus

Service