Atlas Copco ETD MT41-100-I06 제품 지침 - 페이지 10

{카테고리_이름} Atlas Copco ETD MT41-100-I06에 대한 제품 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Atlas Copco ETD MT41-100-I06 16 페이지. Handheld transducerized

Operation

Configuration Instructions

To start the tightening process, press the start lever (A). By default, you need to hold the lever during the

whole tightening process.

For other start modes, refer to Start options [Page 11].

The front light will turn red if the tightening is fault.

There are two unscrew modes:

■

Standard (default): run the tool in CCW.

■

Single reverse: run the tool in CCW once and shift back in CW when tightening is ready.

To start the unscrew process:

Press the function button (B) once. The reverse light (C) is on.

If the reverse light (C) is flashing, single reverse mode is selected.

press the start lever (A).

ETD MT41-100-I06