Atlas Copco ETV ST81-100-13-SH 제품 지침 - 페이지 6

{카테고리_이름} Atlas Copco ETV ST81-100-13-SH에 대한 제품 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Atlas Copco ETV ST81-100-13-SH 16 페이지. Electric angle nutrunner 20-100 nm

페이지 인쇄

Product Information

Country of Origin

For the Country of Origin, please refer to the information on the product label.

Dimensional Drawings

Dimensions Drawings can be found either in the Dimensional Drawings Archive, or on ServAid.

Please visit:

http://webbox.atlascopco.com/webbox/dimdrw

Overview

The Tensor system

The Tensor system consists of a range of tightening tools powered by brushless electric motors and differ-

ent drive units.

Motors are available in different sizes. All tools are protected from overheating of the motor. Electrical pro-

tection system is based on an earth fault circuit brake, Earth Fault Protector (EFP). The EFP senses small

current leakage (>30mA) and if leakage occurs, the drive is switched off (30ms). Changing, interfering or

tampering with the protection system voids all warranty and obligations from Atlas Copco. Trouble-shoot-

ing and re-start of the system may only be carried out by an authorized person. Check the function of the

EFP on a regular basis by pressing the trip-button. The EFP should switch off accordingly.

Technical Product Data

Technical Product Data can be found on either ServAid, or the Atlas Copco website.

Please visit:

https://servaid.atlascopco.com

Service Overview

Service recommendations

Preventive maintenance is recommended at regular intervals. See the detailed information on preventive

maintenance. If the product is not working properly, take it out of service and inspect it.

If no detailed information about preventive maintenance is included, follow these general guidelines:

■

Clean appropriate parts accurately

■

Replace any defective or worn parts

or www.atlascopco.com.

or https://servaid.atlascopco.com.

ETV ST81-100-13-SH