Atlas Copco ETVST101-370-20F 제품 지침 - 페이지 8
{카테고리_이름} Atlas Copco ETVST101-370-20F에 대한 제품 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Atlas Copco ETVST101-370-20F 20 페이지. Electric angle nutrunner
Installation
Installation
Installation requirements
Tool display
The tool display is turned on from the controller.
On Power Focus 4000:
■
Push the Prog button
■
Use the navigation buttons to follow the path > Tool > Configuration > Accessory bus > ST bus >
Mode
Connecting the tool
The tool should, via its correct Power Focus drive unit, be connected to the mains, 230V/50Hz alterna-
tively 115V/ 60Hz, single phase. See instructions for your Power Focus drive unit.
Grounding
If the tool is mounted in a handheld or hand guided fixture, the fixture should be connected to the drive us-
ing a separate 2.5mm
Socket release function
It is recommended to use the socket release function on all the ETP ST101 tools. When the function is en-
abled, the socket rotates backwards 3° after a completed tightening. The aim is to reduce tension on the
reaction bar and to make it easier to remove the tool.
The socket release function is turned on from the controller.
On Power Focus 4000:
■
Push the Prog button
■
Use the navigation buttons to follow the path > Pset > Programming+ > Options > Socket release >
Mode On
Installation instructions
Installation
The tool should, via its correct POWER FOCUS/drive unit, be connected to the mains, 230V/ 50Hz alter-
natively 115V/ 60Hz, single phase. See instructions for your POWER FOCUS/ drive unit.
Fitting of the tool cable:
■
Security check that the cabletype is correct
■
Align the cable connector using the two asymmetrically positioned heads on the connector to fit in the
slots in the tool handle.
■
Tighten the lock nut.
■
Security check that the connection is correct by pulling, pushing and turning the cable connector
(there should be no movement).
The tool has a built in electronic memory chip that will transmit the torque transducer calibration value
and angle pulses to the POWER FOCUS/drive unit. Any changes made of these values in the
POWER FOCUS while the tool is connected will be stored in the tool memory.
8
2
grounding cable.
© Atlas Copco Industrial Technique AB - 9836 8433 01
EN
ETVST101-370-20F