Bose 161 소유자 매뉴얼 - 페이지 5

{카테고리_이름} Bose 161에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose 161 12 페이지. Bose 161 speakers owner's guide
Bose 161에 대해서도 마찬가지입니다: 소유자 매뉴얼 (19 페이지), (영어) 사용 설명서 (8 페이지), (독일어) 사용 설명서 (8 페이지), (네덜란드어) 사용 설명서 (8 페이지)

Preparing speaker cord

Figure 2

Making speaker

wire connections

Connecting speaker cord to your receiver or ampliﬁer

AM257524_01_V.pdf

Speaker cord consists of two insulated wires. The insulation

around one wire is striped, collared, or ribbed. This marked wire is

always positive (+). The plain wire is always negative (–). These

correspond to the positive (red) and negative (black) terminals on

the back of each speaker, receiver, or ampliﬁer. Be sure to connect

each wire to the proper terminal (+ to +, – to –).

Note: Be sure to cut enough cord to reach from the receiver to

each speaker.

At the ends of each cord, strip approximately 1⁄2 inch (1.3 cm) of

insulation from both wires. Twist the bare ends of each wire so

there are no loose strands.

Locate the terminals on the back of each speaker. Depress the red

terminal button (Figure 2), insert the marked (+) wire and release

the button. Depress the black terminal button, insert the plain (–)

wire and release the button.

Connect the left speaker cord to the left channel speaker output of

your receiver or ampliﬁer. Attach the marked wire to the red (+) ter-

minal and the plain wire to the black (–) terminal. In the same man-

ner, connect the right speaker cord to the right channel speaker

output.

CAUTION: Make sure no loose strands of wire touch across termi-

nals. This could create a short circuit that can damage an ampli-

ﬁer or receiver. Secure any loose wires before you plug in the

receiver or ampliﬁer.

Note: If these speakers are used for the rear surround channels in

a home theater system, choose the "SMALL SPEAKER" setting.

October 26, 2001

Black (–)

Setup

Red (+)